Leightronix LabVault-SD Installation, Configuration, And Operation Manual
                                       | |
Contents
| 
Page 6 2018-06-08LABvault-SDSystem InstallationENTERING NETWORK SETTINGS INTO LABVAULT-SDCONFIG MENUEdit unit addressa. Power up the LABvault-SD by pressing the green check button onthe front panel for at least two seconds.b. From the front panel, enter your password by pressing the right arrow button to display the password entryscreen and then the right arrow key five times. If the password is entered correctly, the LABvault-SD’sconfiguration menu will be displayed (see below).If the password is entered incorrectly, the front panel display returns to the status screens.c. Either enter your LABvault-SD network addresses manually or use DHCP to automatically configure the addressesaccording to the following steps:• Automatic Network Addressing: enable DHCP on your LABvault-SD according to the table below. Whenenabled, DHCP will configure your LABvault with an IP, subnet mask, and gateway network addresses.•• Manual Network Address EntryObtain an IP address, subnet mask, and a gateway for your LABvault-SD from your network administrator.Repeat the network configuration steps below to enter your IP, subnet, and gateway network addresses.DHCP Configuration Steps Corresponding Screen Displaysi. From the “CONFIG MENU” screen, press “↑” or “↓“ toproceed to the “Edit DHCP” screen.ii. Press “→“ to select the screen.iii. Press “↑ “ or “↓ “ to toggle the field value from“DISABLED” to “ENABLED.”iv. Press “→“ to enter the next screen.v. Either press “→“ again to save your changes or “←“ toabort changes.The LABvault-SD must be powered down and then powered back up to apply any DHCP changes(press the red “X” button for four seconds to turn the unit off and then press the green checkbutton for two seconds to return power).ENABLE DHCP:ENABLEDPress ~ toconfirm DHCPCONFIG MENUEdit DHCPNetwork Address Configuration Steps Corresponding Screen Displaysi. From the “CONFIG MENU” screen, press “↑” or “↓“ toproceed to the desired address screen.ii. Press “→“ to select the screen.iii. Press “→“ or “←“ to position the underscore beneath theeditable fields and press “↑“ or “↓“ to edit the values.iv. Press “→“ past all of the editable fields to enter the nextscreen.v. Either press “→“ again to save your changes or “←“ toabort changes.The LABvault-SD must be powered down and then powered back up to apply any network addresschanges (press the red “X” button for four seconds to turn the unit off and then press the greencheck button for two seconds to return power).Enter address255. 0. 0. 0.CONFIG MENUEdit unit addressPress ~ toconfirm addressDefault Front Panel Password:five right arrow keys |
Related manuals for Leightronix LabVault-SD
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine