6 ENINTRODUCTIONAttaching the StandYou must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.5Note:• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,resulting in injuries as well as damage to the unit.• Make sure to use a table which can support the weight of this unit and is larger than this unit.• Make sure the table is in a stable location.Supplied Accessories51 Spread a thick and soft cloth over atable.Place the main unit face down onto it.Make sure not to damage the screen.2 Hang the hook under the bottomof the main unit to the stand’s hole(shown arrow ➀), then slide down thestand in the direction of the screen(shown arrow ➁).Make sure not to put the AC powercord between the stand and theunit.3 Drive Phillips pan screws in the 3threaded holes at the bottom of thestand with a screwdriver tightly.To remove the stand from this unitUnscrew the Phillips pan screws indicated by “➂”. Pull up the stand in the direction of the rear of the unit. Be careful not to drop the standwhen you remove it.AAAAAAscrew holesfront sidefront sideTilt StandYou can adjust the stand to change the angle of the unit (-2.5° to 10°).5 -2.5° 10°If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll freecustomer support line found on the cover of this manual.•user manual(1EMN24399)quick start guide(1EMN24400)remote control(NF801UD)batteries(AAA x 2)Phillips pan screw forattaching the stand x 3(FPH34120)
