English51 NoticeMAGNAVOX is a registered trademark of Philips Electronics NorthAmerica Corporation and is used by Funai Electric Co., Ltd. andFunai Corporation, Inc. under license from Philips Electronics NorthAmerica.Funai reserves the right to change products at any time without beingobliged to adjust earlier supplies accordingly.The material in this Owner’s Manual is believed adequate for theintended use of the system. If the product or its individual modules orprocedures are used for purposes other than those specified herein,confirmation of their validity and suitability must be obtained. Funaiwarrants that the material itself does not infringe any United Statespatents. No further warranty is expressed or implied.Funai cannot be held responsible neither for any errors in the contentof this document nor for any problems as a result of the content in thisdocument. Errors reported to Funai will be adapted and published onthe Funai support website as soon as possible.Pixel characteristicsThis LCD product has a high number of color pixels. Although it haseffective pixels of 99.999% or more, black dots or bright points of light(red, green or blue) may appear constantly on the screen. This is astructural property of the display (within common industry standards)and is not a malfunction.WarrantyNo components are user serviceable. Do not open or remove coversto the inside of the product. Repairs may only be done by ServiceCenters and official repair shops. Failure to do so shall void anywarranty, stated or implied.Any operation expressly prohibited in this Owner’s Manual, anyadjustments or assembly procedures not recommended or authorizedin this Owner’s Manual shall void the warranty.Federal Communications Commission NoticeThis equipment has been tested and found to comply with the limitsfor a Class B Digital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipmentgenerates, uses and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructions, may causeharmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or televisionreception, which can be determined by Turning the equipment Off andOn, the user is encouraged to try to correct the interference by oneor more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and the receiver.• Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected.• Consult the dealer or an experienced radio or television technicianfor help.Declaration of ConformityTrade Name : MAGNAVOXResponsible Party : FUNAI CORPORATION, Inc.Model : 32MV402X, 26MV402X, 22MV402X,Address : 19900 Van Ness Avenue, Torrance, CA 90501U.S.A.Telephone Number : 1 866 341 3738ModificationsThis apparatus may generate or use radio frequency energy. Changes ormodifications to this apparatus may cause harmful interferenceunless the modifications are expressly approved in the Owner’s Manual.The user could lose the authority to operate this apparatus if anunauthorized change or modification is made.CablesConnections to this device must be made with shielded cables withmetallic RFI / EMI connector hoods to maintain compliance with FCCRules and Regulations.Canadian noticeThis Class B Digital apparatus complies with Canadian ICES-003.Standard Television Receiving Apparatus, Canada BETS-7 / NTMR-7.ThefollowingFCC/ICRSS-GenisdescriptionofUSBWirelessLANadapter.FCC Caution: Any changes or modifications not expressly approvedby the party responsible for compliance could void the user’sauthority to operate this equipment.This transmitter must not be co-located or operating in conjunctionwith any other antenna or transmitter.Country Code StatementFor product available in the USA market, only channel 1~11 can beoperated. Selection of other channels is not possible.To maintain compliance with FCC RF exposure requirements, useonly belt-clips, holsters or similar accessories that do not containmetallic components in its assembly. The use of accessories that donot satisfy these requirements may not comply with FCC RF exposurerequirements and should be avoided.FCC Radiation Exposure StatementThis equipment is compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-1999 and had beentested in accordance with the measurement methods and proceduresspecified in OET Bulletin 65 Supplement C. This equipment shouldbe installed and operated with minimum distance 2.5cm between theradiator & your body.This device complies with Industry Canada license-exempt RSSstandard(s). Operation is subject to the following two conditions: (1)this device may not cause interference and (2) this device must acceptany interference, including interference that may cause undesiredoperation of the device.