Magnavox MWC24T5 Owner's Manual

Also see for MWC24T5: Service manual Owner's manual

ENAUXSLEEP 0 MINUTEBRIGHT– PP PP PP PP PP PP PP CC PP PP PP PP PP PP PP +SLEEP TIMER SETTINGThe Sleep Timer function is used to turn off theunit without pressing [STANDBY-ON yy] after adesired time.1 Press [PICTURE / SLEEP] todisplay the Sleep Timer menu.2 Within 5 seconds, set your desired sleep timeusing [s / B].• [B]...Increase by 30 min. (Up to 120 min.)• [s]...Decrease by 30 min.NOTE:• To cancel the Sleep Timer, use [CLEAR] or [s / B]to set the time to "0".3 To confirm the remainder time to shutdown,press [PICTURE / SLEEP].PICTURE CONTROL1 Press [PICTURE / SLEEP]repeatedly until desired controlis displayed.2 Use [s / B] to adjust to your desired level within5 seconds.• Even if any power failure occurs, the unit willretain its memory for this feature.COLORTINTSHARPNESSBRIGHTCONTRASTto paleto purpleto softto decrease brightnessto decrease contrastto brilliantto greento clearto increase brightnessto increase contrastVOLUME 20C C C C C C C C C C C C C C C CTV/VCRTV/VCR9TV OPERATION AND SETTINGSTV/VCR SECTIONWATCHING A TV PROGRAMTV/VCRTV/VCROPERATING CONTROLS AND FUNCTIONS / TV OPERATION AND SETTINGS TV/VCR SECTION1 After antenna or cable connection iscompleted, connect the power cord intoa standard AC outlet.2 Press [STANDBY-ON yy] to turn on the unit.3 Use [CH. K / L] or the Number buttons toselect your desired channel number.4 Use [VOL. X / Y] to adjust the volume.Press [MUTE] to instantlymute the sound. Press it againto restore the previous soundlevel.NOTE:• Even if you turn off the unit in the DVD mode, the unitwill be in the TV/VCR mode when you turn it on again.TO WATCH CABLE OR SATELLITE CHANNELIf the unit is connected to a cable box or satellitebox, use [CH. K / L] to select CH3 or CH4 accord-ing to the output channel setting of the device andselect desired channel on that device.TO WATCH EXTERNAL INPUTWhen an external equipment isconnected to the front AUDIO/VIDEO input jacks, press[SELECT] or [CH. K / L] repeat-edly until "AUX" appears on thescreen.NOTE:• If there is no signal input from the antenna terminaland no operation for 15 minutes, the unit will turnitself off automatically.SLEEP TIMER / PICTURE CONTROLYou can set Sleep Timer and pictureadjustment with [PICTURE / SLEEP].• The menu changes as described below every timeyou press [PICTURE / SLEEP].Sleep Timer BRIGHT CONTRASTCOLORTINTSHARPNESSTo use the number buttons•Single digit channels: (Ex. 02, 03, 04 and so on)Press [0] first to select a single digit channel.•Two digit channels: (Ex. 12, 38, 95 ...)Press two digits directly.•Three digit channels: (Ex. 115, 125 ...)Press [+100] first, then press the last two digits.