Contents - contact information
- important safety instructions
- Table Of Contents
- Table Of Contents
- Introduction
- Figure 1-1, Power Switch, Status LED and Accessory Connection Ports
- Features and Benefi ts
- Figure 1-3, Left Side Features
- How the MS-PAE Series Inverter/Charger Works
- Installation 2.0 Installation
- Figure 2-1, Simplifi ed Installation Diagram - Single Inverter
- Figure 2-2, Approved Mounting Positions
- Figure 2-3, MS-PAE Series Dimensions
- Grounding Inverters
- Table 2-1, AC Grounding Electrode Conductor Sizing
- Table 2-2, Equipment Grounding Conductor Sizing
- DC Wiring
- Figure 2-8, DC and Battery Temperature Sensor Wiring
- Table 2-3, Recommended DC Wire/Overcurrent Device
- Figure 2-9, Battery Hardware Installation
- Figure 2-11, Battery Temperature Sensor
- AC Wiring
- Figure 2-12, AC Terminal Block
- Figure 2-13, AC Wiring
- Inverter Warning Label
- Functional Test
- Operation 3.0 Operation
- Standby Mode
- Figure 3-3, Automatic 4-Stage Charging Graph
- Battery Temperature Sensor Operation
- Protection Circuitry Operation
- Start-Up
- Factory Default Values
- Table 4-1, Troubleshooting Guide
- Performing an Inverter Reset
- Overview
- Figure 5-1, Simplifi ed Installation Diagram - Multiple Inverters (stacked in parallel)
- Parallel System Connections and Components
- Specifi cations A.1 Specifi cations
- A.2 Effi ciency Graphs
- Optional Equipment/Accessories B.1 Optional Equipment/Accessories
- Table C-1, Typical Appliance Power Consumption
- C.2 Battery Bank Sizing Worksheet
- C.3 Battery Wiring
- Figure C-4, Battery Bank Wiring Examples (24-volt)
- Figure C-5, Battery Bank Wiring Examples (48-volt)
- Warranty and Service D.1 Limited Warranty
|
© 2009 Magnum Energy IncPage 4Introduction1 61 41 51 3Figure 1-3, Left Side FeaturesThe left side of the MS-PAE Series is equipped with the following features (refer to figure 1-3):13 Exhaust Air Vent - ventilation openings that allows heated air to be removed by theinternal cooling fan.14 Model/Serial Number Label - includes model/serial number information, date ofmanufacture and inverter and charger specifications. See the MS-PAE Specificationsin Appendix A for more information and the different models available.15 AC Access Cover - provides access to the internal AC wiring terminal block. This terminalblock is used to hardwire all inverter AC input and output wiring connections. Remove thetwo screws to access the AC wiring terminal block.16 Input circuit breakers - these circuit breakers protect the unit’s internal wiring andpass-thru relay on each input (L1 and L2) while in the standby mode. These input circuitbreakers are not branch-circuit rated. These circuit breakers pop out when they open,press in to reset power capacity.CAUTION: Circuit breakers that branch-circuit rated must be installed in the invert-er’s input and output wiring.CAUTION: The inverter’s internal AC transfer relay is rated for 30 amps per leg, thepass-thru current must be no greater than 30 amps per leg or damage to the relaysmay occur.AC ACCESSCOVERM ODEL/SERIALNUMBER LABELEXHAUSTAIR VENTS(BACK SIDE)I NPUT CIRCUIT BREAKERS
|
