Magnum Energy MS-PAE Series Owner's Manual

Contents

Magnum Energy MS-PAE Series Owner's Manual Manual pdf 9 page image

Page 3© 2009 Magnum Energy Inc.1.1 Features and BenefitsThe MS-PAE Series inverter/charger is designed to allow easy access to wiring, circuit breakers,controls and for viewing the LED (Light Emitting Diode) status indicator. Its die cast base-platewith one piece aluminum cover ensures maximum durability with minimum weight, as well ascooler more efficient operation.The front of the MS-PAE Series is equipped with the following features (refer to figures 1-1 and1-2):1 Power Switch - a momentary push-button switch that alternately turns the inverter Onor Off.2 Status LED Indicator - this green LED illuminates to provide information on the in-verter or charger operation.3 Parallel Stack Connection Port (red label) - a RJ45 port that connects to the ME-RTRRouter, which is used to configure and synchronize multiple MS-PAE units to operate inparallel for increase power capacity.CAUTION: Connect this Parallel Stack Port connection only to the ME-RTR.Although the cabling and connectors used in this network system are the same asEthernet connectors, this network is not an Ethernet system. Attempting to connectthese two different systems may cause damage and is not covered under warranty.Info: The MS-PAE Series Inverters cannot not be connected in parallel without in-stalling the optional ME-RTR.4 Magnum Net Connection Port (green label) - a RJ11 port that accepts optional Net-work capable accessories (i.e. Auto Gen Start or Battery Monitor).5 Remote Connection Port (blue label) - a RJ11 port that allows optional remote controldisplays (i.e. ME-RC, ME-ARC, ME-RTR) to be connected.6 BTS Connection Port (yellow label) - RJ11 port that accepts the remote Battery Tem-perature Sensor (BTS) accessory.7 DC Equipment Ground Terminal - this connection is used to tie the exposed chassis ofthe inverter to the DC grounding system. This terminal accepts CU/AL conductors from#14 to #2 AWG (2.1 to 33.6 mm2).8 AC Entry/Exit Connections - two 3/4” knockouts provided with cable-clamp strain reliefsto allow and hold the AC input and output field wiring.9 Intake Air Vents - ventilation openings to pull in air to help keep the inverter cool forpeak performance.10 Positive DC Terminal - provides 360 degree connection point for the positive (+) cablefrom the battery bank; provided with a 5/16-18 stainless Kep or Flange nut on a 5/16-18bolt (5/8” usable length) to hold the battery cable to the DC terminal which uses.11 Negative DC Terminal - provides 360 degree connection point for the negative (-) cablefrom the battery bank; provided with a 5/16-18 stainless Kep or Flange nut on a 5/16-18bolt (5/8” usable length) to hold the battery cable to the DC terminal.12 Mounting Flange - used to secure the inverter to a shelf or wall.Introduction