67659830 m3 meters= wearing Protective Equipment- Always wear safety shoes or boots (G) with steel toes, non-skidsoles, and leg protectors when working with the Power Cut.Safety shoes equipped with a protective layer provide protectionagainst cuts and ensure a secure footing.- Always wear a work suit (H) of tough material with sufficientflame-retardant qualities whenever working with the cutoffsaw.Fuels / Refuelling- Go to a safe, level place before refuelling. Never refuel whileon scaffolding, on heaps of material, or in similar places!- Switch off the engine before refuelling the Power Cut.- Do not smoke or work near open fires (6).- Let the engine cool down before refuelling.- Fuels can contain substances similar to solvents. Eyes and skinshould not come in contact with mineral oil products. Always wearprotective gloves when refuelling (not the regular work gloves!).Frequently clean and change protective clothes. Do not breathein fuel vapors. Inhalation of fuel vapours can be hazardous toyour health.- Do not spill fuel. If a spill occurs, clean off the Power Cut im-mediately. Fuel should not come in contact with clothes. If yourclothes have come in contact with fuel, change them at once.- Ensure that no fuel oozes into the soil (environmental protection).Use an appropriate base.- Refuelling is not allowed in closed rooms. Fuel vapors will ac-cumulate near the floor (explosion hazard).- Ensure to firmly tighten the screw cap of the fuel tank.- Before starting the engine, move to a location at least 3 meters(approx. 10 feet) from where you fuelled the Power Cut (7), butnot within the extended swing range of the cutting disc (directionof sparks).- Fuel cannot be stored for an unlimited period of time. Buy onlyas much as will be consumed in the near future.- When making up the gasoline/oil mixture, always put the oil inthe mixing container first, and then the gasoline.- Use only approved and marked containers for the transport andstorage of fuel.- Keep fuel away from children!Putting into operation- Do not work on your own. There must be someone aroundin case of an emergency (within shouting distance).- Observe all anti-noise regulations when working in residentialareas.- Never use the Power Cut near inflammable materials orexplosive gases! The Power Cut can create sparks leadingto fire or explosion!- Make sure that all persons within 30 meters (100 feet), suchas other workers, are wearing protective gear (see "ProtectiveEquipment") (8). Children and other unauthorized persons mustremain more than 30 meters away from the working area. Keepan eye out for animals as well (9).- Before starting work the Power Cut must be checked forperfect function and operating safety according to the pre-scriptions. In particular, make sure that the cutting wheel is ingood condition(replace immediately if torn, damaged or bent),the cutting wheel is properly mounted, the protective hood islocked in place, the hand guard is properly mounted, the V-belthas the proper tension, the throttle moves easily and the half-throttle lock button functions properly, the grips are clean anddry, and the combination switch functions properly (Start/Stop(I/O) switch, choke). Visually inspect the muffler for damage andpossible dirt in the muffler area.- Start the Power Cut only after complete assembly and inspec-tion. Never use the Power Cut when it is not completely as-sembled.