Makita EK7650H Original Instruction Manual

Also see for EK7650H: Instruction manual Owner's and safety manual Instruction manual Original instruction manual Instruction manual

7Kickback and lock-in- When working with the Power Cutter there is a danger of kickback and lock-in.- Kickback occurs when the top of the cutting disc is used for cutting (15).- This causes the Power Cutter to be thrown back toward the user with great forceand out of control. Risk of injury!To prevent kickback, observe the following:- Never cut with the section of the cutting disc shown in figure 15.Be especially careful when reinserting the disc into cuts that have alreadybeen started!- Lock-in occurs when the cut narrows (crack, or workpiece under stress).- This causes the Power Cutter to suddenly jump forward, out of control and withgreat force. Risk of injury!To prevent lock-in, observe the following:- When reinserting the disc into previous cuts, have the Power Cutter running attop speed. Always cut at top speed.- Always support the workpiece so that the cut is under tension (16), so that thecut does not press together and jam the cutting disc as it proceeds through thematerial.- When starting a cut, apply the disc to the workpiece with care.Do not just shove it into the material.- Never cut more than one piece at a time! When cutting, make sure that no otherworkpiece comes into contact.Working behavior / Method of working- Before starting work, check the work area for any hazards (electrical wires,inflammable substances). Clearly mark the work area (for example with warningsigns or by cordoning off the area).- When working with the Power Cutter hold it firmly by the front and rear handles.Never leave the Power Cutter unattended!- Whenever possible run the Power Cutter at the rated arbour speed (see“Technical data”).- Only use the Power Cutter during good light and visibility periods.Be aware of slippery or wet areas, and of ice and snow (risk of slipping).- Never work on unstable surfaces. Make sure that there are no obstacles in theworking area, risk of stumbling. Always ensure that you have a safe footing.- Never cut above your shoulder height (17).- Never stand on a ladder to cut (17).- Never use the Power Cutter while standing on scaffolding.- Do not lean over too far when working. When putting down and picking up thePower Cutter, do not bend over from the waist, but instead bend in the knees.Save your back!- Guide the Power Cutter in such a way that no part of your body is within theextended swing range of the disc (18).- Use cutting discs only for the materials for which they are designed!- Do not use the Power Cutter to lift up and shovel away pieces of material andother objects.Important! Before cutting, remove all foreign objects, such as rocks, gravel, nailsetc. from the cutting area. Otherwise, such objects can be flung away by the discwith great speed. Injury hazard!- When cutting workpieces down to length use a firm support. If necessary, securethe workpiece from slipping, but do not steady it with your foot or allow anotherperson to hold it.- When cutting round items, always secure them against rotation.- When guiding the Power Cutter by hand, use the side mounting position of thecutter attachment only when actually necessary.Otherwise, always use the central position. This gives the unit a better balance,for reduced operator fatigue.15161718