Makita LS0714 Instruction Manual
Also see for LS0714: Instruction manualInstruction manualInstruction manualParts BreakdownInstruction manual
                        | |
13The maximum width of the workpiece which can besecured by the horizontal vise is 120 mm.CAUTION:• Grip the workpiece only when the projection is atthe topmost position. Failure to do so may result ininsufficient securing of the workpiece. This couldcause the workpiece to be thrown, cause damageto the blade or cause the loss of control, which canresult in PERSONAL INJURY.Holders and holder assembly(optional accessories)1 2002247The holders and the holder assembly can be installed oneither side as a convenient means of supportingworkpieces horizontally. Install them as shown in thefigure. Then tighten the screws firmly to secure theholders and the holder assembly.When cutting long workpieces, use the holder-rodassembly (optional accessory). It consists of two holderassemblies and two rods 12.21002246CAUTION:• Always support long workpieces level with the topsurface of the turn base for accurate cuts and toprevent dangerous loss of control of the tool.OPERATIONCAUTION:• Before use, be sure to release the handle from thelowered position by pulling the stopper pin.• Make sure the blade is not contacting theworkpiece, etc. before the switch is turned on.• Do not apply excessive pressure on the handlewhen cutting. Too much force may result inoverload of the motor and/or decreased cuttingefficiency. Push down handle with only as muchforce as is necessary for smooth cutting andwithout significant decrease in blade speed.• Gently press down the handle to perform the cut. Ifthe handle is pressed down with force or if lateralforce is applied, the blade will vibrate and leave amark (saw mark) in the workpiece and the precisionof the cut will be impaired.• During a slide cut, gently push the carriage towardthe guide fence without stopping. If the carriagemovement is stopped during the cut, a mark will beleft in the workpiece and the precision of the cut willbe impaired.1. Press cutting (cutting small workpieces)12005524Workpieces up to 50 mm high and 97 mm wide canbe cut in the following way.Push the carriage toward the guide fence fully andtighten two clamp screws which secure the slidepoles clockwise to secure the carriage. Secure theworkpiece with the vise. Switch on the tool withoutthe blade making any contact and wait until theblade attains full speed before lowering. Thengently lower the handle to the fully lowered positionto cut the workpiece. When the cut is completed,switch off the tool and WAIT UNTIL THE BLADEHAS COME TO A COMPLETE STOP beforereturning the blade to its fully elevated position.CAUTION:• Firmly tighten two clamping screws which securethe slide poles clockwise so that the carriage willnot move during operation. Insufficient tighteningmay cause unexpected kickback of the blade.Possible serious PERSONAL INJURY may result.1. Two clampingscrews whichsecure the slidepole2. Holder assembly(optionalaccessory)1. Holderassembly2. Rod 121. Holder2. Holderassembly |
Related manuals for Makita LS0714
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
manualsdatabase
Your AI-powered manual search engine