Makita LS0714 Instruction Manual
Also see for LS0714: Instruction manualInstruction manualInstruction manualParts BreakdownInstruction manual
                        | |
20Replacing fluorescent tubeFor model LS0714F, LS0714FL only1 23 415002028CAUTION:• Always be sure that the tool is switched off andunplugged before replacing the fluorescent tube.• Do not apply force, impact or scratch to afluorescent tube, which can cause a glass of thefluorescent tube to be broken resulting in a injury toyou or your bystanders.• Leave the fluorescent tube for a while immediatelyafter a use of it and then replace it. If not. You mayburn yourself.Remove screws, which secure Lamp Box for the light.Pull out the Lamp Box keeping pushing lightly the upperposition of it as illustrated on the left.Pull out the fluorescent tube and then replace it withMakita original new one.Cleaning of the lens for the laser lightFor model LS0714FL, LS0714L123005703If the lens for the laser light becomes dirty, or sawdustadheres to it in such a way that the laser line is no longereasily visible, unplug the saw and remove and clean thelens for the laser light carefully with a damp, soft cloth.Do not use solvents or any petroleum-based cleaners onthe lens.1005704To remove the lens for the laser light, remove the sawblade before removing the lens according to theinstructions in the section titled "Installing or removingsaw blade".Loosen but do not remove the screw which secures thelens using a screwdriver.Pull out the lens as shown in the figure.NOTE:• If the lens does not come out, loosen the screwfurther and pull out the lens again without removingthe screw.Replacing carbon brushes1001145Remove and check the carbon brushes regularly.Replace when they wear down to the limit mark. Keepthe carbon brushes clean and free to slip in the holders.Both carbon brushes should be replaced at the sametime. Use only identical carbon brushes.Use a screwdriver to remove the brush holder caps. Takeout the worn carbon brushes, insert the new ones andsecure the brush holder caps.12003946After use• After use, wipe off chips and dust adhering to thetool with a cloth or the like. Keep the blade guard1. Brush holder cap2. Screwdriver1. Limit mark1. Lens for thelaser light1. Screwdriver2. Screw(one piece only)3. Lens for thelaser light1. Pull out2. Push3. Lamp box4. Screws5. Fluorescent tube |
Related manuals for Makita LS0714
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
Makita LS0714 Instruction Manual
manualsdatabase
Your AI-powered manual search engine