Makita LS0714 Instruction Manual

Also see for LS0714: Instruction manual Instruction manual Instruction manual Parts Breakdown Instruction manual

Contents

8With the tool unplugged, rotate the blade by hand whileholding the handle all the way down to be sure that theblade does not contact any part of the lower base.Re-adjust slightly, if necessary.WARNING:• After installing a new blade, always be sure that theblade does not contact any part of the lower basewhen the handle is lowered completely. Always dothis with the tool unplugged.Stopper arm12003928The lower limit position of the blade can be easilyadjusted with the stopper arm. To adjust it, move thestopper arm in the direction of the arrow as shown in thefigure. Adjust the adjusting screw so that the blade stopsat the desired position when lowering the handle fully.Adjusting the miter angle1 23 4 5003929Loosen the grip by turning counterclockwise. Turn theturn base while pressing down the lock lever. When youhave moved the grip to the position where the pointerpoints to the desired angle on the miter scale, securelytighten the grip clockwise.CAUTION:• When turning the turn base, be sure to raise thehandle fully.• After changing the miter angle, always secure theturn base by tightening the grip firmly.Adjusting the bevel angle12003930123003931To adjust the bevel angle, loosen the lever at the rear ofthe tool counterclockwise.Push the handle to the left to tilt the saw blade until thepointer points to the desired angle on the bevel scale.Then tighten the lever clockwise firmly to secure the arm.To tilt the blade to the right, push the release button at therear of the tool while tilting the blade slightly to the leftafter loosening the lever. With the release buttondepressed, tilt the saw blade to the right.CAUTION:• When tilting the saw blade, be sure to raise thehandle fully.• After changing the bevel angle, always secure thearm by tightening the lever clockwise.• When changing bevel angles, be sure to positionthe kerf boards appropriately as explained in the"Positioning kerf boards" section.Adjusting the lever position1 2003932The lever can be repositioned at every angle 30° whenthe lever does not provide full tightening.Loosen and remove the screw that secures the lever atthe rear of the tool. Remove the lever and install it again1. Lever2. Screw1. Pointer2. Bevel scale3. Arm1. Lever2. Release button1. Turn base2. Lock lever3. Miter scale4. Pointer5. Grip1. Adjusting screw2. Stopper arm

/ 24

Related manuals for Makita LS0714

Makita LS0714 Instruction Manual

This manual is suitable for:

LS0714 LS0714FL LS0714F LS0714L

manualsdatabase

Your AI-powered manual search engine