Makita LS0714 Instruction Manual

Also see for LS0714: Instruction manual Instruction manual Instruction manual Parts Breakdown Instruction manual

Contents

21Carrying toolMake sure that the tool is unplugged. Secure the blade at 0° bevel angle andthe turn base at right miter angle fully. Secure the slide poles after pulling thecarriage toward the guide fence fully. Lower the handle fully and lock it in thelowered position by pushing in the stopper pin.Carry the tool by holding both sides of the tool base as shown in the figure. Ifyou remove the holders, dust bag, etc., you can carry the tool more easily.CAUTION:• Always secure all moving portions before carrying the tool.• Stopper pin is for carrying and storage purposes only and not for anycutting operations.MAINTENANCE CAUTION:• Always be sure that the tool is switched off and unplugged beforeattempting to perform inspection or maintenance.WARNING:• Always be sure that the blade is sharp and clean for the best and safestperformance.Adjusting the cutting angleThis tool is carefully adjusted and aligned at the factory, but rough handlingmay have affected the alignment. If your tool is not aligned properly, performthe following:1. Miter anglePush the carriage toward the guide fence and tighten two clamp screwsto secure the carriage.Loosen the grip which secures the turn base. Turn the turn base so thatthe pointer points to 0° on the miter scale. Then turn the turn baseslightly clockwise and counterclockwise to seat the turn base in the 0°miter notch. (Leave as it is if the pointer does not point to 0°.) Loosen thehex bolts securing the guide fence using the socket wrench.1. Stopper pin10039230057001. Guide fence2. Hex bolt1 2002242

/ 28

Related manuals for Makita LS0714

Makita LS0714 Instruction Manual

This manual is suitable for:

LS0714 LS0714FL LS0714F LS0714L

manualsdatabase

Your AI-powered manual search engine