Makita LS0714 Instruction Manual

Also see for LS0714: Instruction manual Instruction manual Instruction manual Parts Breakdown Instruction manual

Contents

23Make sure that the pointer on the arm point to 0° on the bevel scaleon the arm holder. If it does not point to 0°, loosen the screw whichsecures the pointer and adjust the pointer so that it will point to 0°.(2) 45° bevel angleAdjust the 45° bevel angle only after performing 0° bevel angleadjustment. To adjust left 45° bevel angle, loosen the lever and tiltthe blade to the left fully. Make sure that the pointer on the armpoints to 45° on the bevel scale on the arm holder. If the pointerdoes not point to 45°, turn the 45° bevel angle adjusting bolt (upperbolt) on the right side of the arm until the pointer points to 45°.Adjusting the position of laser lineFor model LS0714FL, LS0714LWARNING:• As the tool is plugged when adjusting the position of laser line, take a fullcaution especially at switch action. Pulling the switch trigger accidentallycause an accidental start of the tool and personal injury.CAUTION:• Never look into the laser beam directly. Direct laser beam causesdamage to your eyes.• Never apply a blow or impact to the tool. A blow or impact causes theincorrect position of laser line, damage to the laser beam emitting part ora short life of the tool.• Have the tool repaired by Makita authorized service center for any failureon the laser unit. No change with different type of laser is permitted.1. Bevel scale2. Pointer3. Screw1 2 30039441. Left 45 degrees bevel angleadjusting bolt10039451. Work piece2. Cutting line3. Holder assembly(optional accessory)1. Vertical vise2. Holder assembly(optional accessory)12300570112005702

/ 28

Related manuals for Makita LS0714

Makita LS0714 Instruction Manual

This manual is suitable for:

LS0714 LS0714FL LS0714F LS0714L

manualsdatabase

Your AI-powered manual search engine