Makita LS1013 Instruction Manual
Also see for LS1013: Instruction manualInstruction manualParts BreakdownInstruction manualInstruction manual
                                                                            | |
5ADDITIONAL SAFETY RULESFOR THE LASERUSB088-1CAUTION:• LASER RADIATION DO NOT STARE INTO BEAM.• AVOID EXPOSURE – LASER RADIATION ISEMITTED FROM APERTURE.• USE OF CONTROLS OR ADJUSTMENTS ORPERFORMANCE OF PROCEDURES OTHER THANTHOSE SPECIFIED HEREIN MAY RESULT INHAZARDOUS RADIATION EXPOSURE.INSTALLATIONBench mountingWhen the tool is shipped, the handle is locked in the low-ered position by the stopper pin. Release the stopper pinby lowering the handle slightly and pulling the stopperpin.This tool should be bolted with four bolts to a level andstable surface using the bolt holes provided in the tool’sbase. This will help prevent tipping and possible injury.FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function onthe tool.Blade guardWhen lowering the handle, the blade guard rises auto-matically. The blade guard returns to its original positionwhen the cut is completed and the handle is raised.NEVER DEFEAT OR REMOVE THE BLADE GUARDOR THE SPRING WHICH ATTACHES TO THE GUARD.In the interest of your personal safety, always maintainthe blade guard in good condition. Any irregular opera-tion of the blade guard should be corrected immediately.Check to assure spring loaded return action of guard.NEVER USE THE TOOL IF THE BLADE GUARD ORSPRING ARE DAMAGED, FAULTY OR REMOVED.DOING SO IS HIGHLY DANGEROUS AND CAN CAUSESERIOUS PERSONAL INJURY.If the see-through blade guard becomes dirty, or sawdustadheres to it in such a way that the blade and/or work-piece is no longer easily visible, unplug the saw andclean the guard carefully with a damp cloth. Do not usesolvents or any petroleum-based cleaners on the plasticguard.If the blade guard is especially dirty and vision throughthe guard is impaired, use the supplied socket wrench toloosen the hex bolt holding the center cover. Loosen thehex bolt by turning it counterclockwise and raise theblade guard and center cover. With the blade guard sopositioned, cleaning can be more completely and effi-ciently accomplished. When cleaning is complete,reverse procedure above and secure bolt. Do not removespring holding blade guard. If guard becomes discolored1. Stopper pinComplies with 21CFR1040.10 and 1040.11AVOID EXPOSURE-Laserradiation is emitted fromLASER RADIATIONthis apertureDO NOT STARE INTO BEAMMaximum Output<1mW,Wavelength:655nmCLASS II LASER PRODUCTCAUTION10015641. Bolt1. Blade guard10015311001535 |
Related manuals for Makita LS1013
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
manualsdatabase
Your AI-powered manual search engine