Makita LS1013 Instruction Manual
Also see for LS1013: Instruction manualInstruction manualParts BreakdownInstruction manualInstruction manual
                                                                            | |
91003826Move the light to shift an area of lighting.NOTE:• Use a dry cloth to wipe the dirt off the lens of lamp.Be careful not to scratch the lens of light, or it maylower the illumination.Laser beam actionFor model LS1013L/LS1013FL only1006339CAUTION:• LASER RADIATIONDo not stare into beam.To turn on the laser beam, press the upper position (I) ofthe switch. Press the lower position (O) to turn off.Laser line can be shifted to either the left or right side ofthe saw blade by adjusting the adjusting screw asfollows.10063401. Loosen the adjusting screw by turning itcounterclockwise.2. With the adjusting screw loosened, slide theadjusting screw to the right or left as far as it goes.3. Tighten the adjusting screw firmly at the positionwhere it stops sliding.Laser line is factory adjusted so that it is positionedwithin 1 mm (0.04") from the side surface of the blade(cutting position).NOTE:• When laser line is dim and almost or entirelyinvisible because of the direct sunlight in the indooror outdoor window-by work, relocate the work areato a place not exposed to the direct sunlight.Aligning the laser lineA B006341Laser line can be shifted to either the left or right side ofthe blade according to the applications of cutting. Referto explanation titled "Laser beam action" regarding itsshifting method.NOTE:• Use wood facing against the guide fence whenaligning the cutting line with the laser line at theside of guide fence in compound cutting (bevelangle 45 degrees and miter angle right 45degrees).A) When you obtain correct size on the left side ofworkpiece• Shift the laser line to the left of the blade.B) When you obtain correct size on the right side ofworkpiece• Shift the laser line to the right of the blade.Align the cutting line on your workpiece with the laserline.ASSEMBLYCAUTION:• Always be sure that the tool is switched off andunplugged before carrying out any work on thetool.1. Adjusting screw1. Switch for laser1. Light switch |
Related manuals for Makita LS1013
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
Makita LS1013 Instruction Manual
manualsdatabase
Your AI-powered manual search engine