Makita LS1214FL Instruction Manual

Also see for LS1214: Instruction manual Instruction manual Instruction manual Parts Breakdown Instruction manual

Contents

23the screws which secure the pointers andadjust them so that they will point to 0°.2133001572(2) 45° bevel angle132001573Adjust the 45° bevel angle only afterperforming 0° bevel angle adjustment. Toadjust left 45° bevel angle, loosen the leverand tilt the blade to the left fully. Make surethat the pointer on the arm points to 45° onthe bevel scale on the arm holder. If thepointer does not point to 45°, turn the left 45°bevel angle adjusting bolt on the side of thearm holder until the pointer points to 45°.To adjust right 45° bevel angle, perform thesame procedure described above.Adjusting for smooth beveling action1 2004860The hex lock nut holding together the arm and armholder has been factory adjusted to assure smoothbeveling action and to guarantee precise cutting. Do nottamper with it. Should looseness develop at the arm andarm holder connection, tighten the hex lock nut using awrench.Adjusting the position of laser lineFor model LS1214L/LS1214FL only12300634212006343WARNING:• As the tool is plugged when adjusting the positionof laser line, take a full caution especially at switchaction. Pulling the switch trigger accidentally causean accidental start of the tool and personal injury.CAUTION:• Never look into the laser beam directly. Direct laserbeam causes damage to your eyes.• LASER RADIATIONDo not stare into beam.• Never apply a blow or impact to the tool. A blow orimpact causes the incorrect position of laser line,damage to the laser beam emitting part or a shortlife of the tool.When adjusting the laser line appears on the leftside of the saw blade1 234 50063451. Screw to change the movable range of the adjustingscrew2. Adjusting screw3. Hex Wrench4. Laser line5. Saw blade1. Vertical vise2. Holder1. Workpiece2. Cutting line3. Holder1. Arm2. Hex lock nut1. Arm holder2. Right 45 ﾟ bevelangle adjustingbolt3. Left 45 ﾟ bevelangle adjustingbolt1. Bevel scale2. Screws3. Pointers