Makita LS1214FL Instruction Manual

Also see for LS1214: Instruction manual Instruction manual Instruction manual Parts Breakdown Instruction manual

Contents

8at the desired position when lowering the handle fully.Adjusting the miter angle12 4 3001541Loosen the grip by turning counterclockwise. Turn theturn base while pressing down the lock lever. When youhave moved the grip to the position where the pointerpoints to the desired angle on the miter scale, securelytighten the grip clockwise.CAUTION:• When turning the turn base, be sure to raise thehandle fully.• After changing the miter angle, always secure theturn base by tightening the grip firmly.Adjusting the bevel angleTo adjust the bevel angle, loosen the lever at the rear ofthe tool counterclockwise. Unlock the arm by pushingthe handle somewhat strongly in the direction that youintend to tilt the saw blade.1004056Tilt the saw blade until the pointer points to the desiredangle on the bevel scale. Then tighten the leverclockwise firmly to secure the arm.123 4001543CAUTION:• When tilting the saw blade, be sure to raise thehandle fully.• After changing the bevel angle, always secure thearm by tightening the lever clockwise.• When changing bevel angles, be sure to positionthe kerf boards appropriately as explained in the"Positioning kerf boards" section.Switch actionCAUTION:• Before plugging in the tool, always check to seethat the switch trigger actuates properly andreturns to the "OFF" position when released.• When not using the tool, remove the lock-off buttonand store it in a secure place. This preventsunauthorized operation.• Do not pull the switch trigger hard without pressingin the lock-off button. This can cause switchbreakage.213001551To prevent the switch trigger from being accidentallypulled, a lock-off button is provided. To start the tool,press in the lock-off button and pull the switch trigger.Release the switch trigger to stop.WARNING:• NEVER use tool without a fully operative switchtrigger. Any tool with an inoperative switch isHIGHLY DANGEROUS and must be repairedbefore further usage.• For your safety, this tool is equipped with a lock-offbutton which prevents the tool from unintendedstarting. NEVER use the tool if it runs when yousimply pull the switch trigger without pressing thelock-off button. Return tool to a Makita servicecenter for proper repairs BEFORE further usage.• NEVER tape down or defeat purpose and functionof lock-off button.Electric brakeThis tool is equipped with an electric blade brake. If thetool consistently fails to quickly stop blade after switchtrigger release, have tool serviced at a Makita servicecenter.1. Lock-off button2. Handle3. Switch trigger1. Arm2. Lever3. Pointer4. Bevel scale1. Lever1. Lock lever2. Grip3. Pointer4. Miter scale