Makita LXSL01 Instruction Manual

Also see for LXSL01: Instruction manual Instruction manual

Contents

15Moldingposition inFig. AMolding edge againstguide fence(1) Ceiling contact edge shouldbe against guide fence.Ceiling contact edge shouldbe against guide fence.ForoutsidecornerFinished piecewill be on theLeft side ofblade.Finished piecewill be on theRight side ofblade.For insidecornerWall contact edge should beagainst guide fence.Finished piece(2)(3)(4)Table (B)006362Example:In the case of cutting 52/38° type crownmolding for position (1) in Fig. A:• Tilt and secure bevel angle setting to33.9° LEFT.• Adjust and secure miter angle setting to31.6° RIGHT.• Lay crown molding with its broad back(hidden) surface down on the turn basewith its CEILING CONTACT EDGEagainst the guide fence on the saw.• The finished piece to be used willalways be on the LEFT side of the bladeafter the cut has been made.In the case of right bevel cutMoldingposition inFig. ABevel angle Miter angleFor outsidecornerFor insidecorner52/38° type 45° typeRight 31.6°45° typeRight 33.9° Right 30°52/38° typeLeft 31.6° Left 35.3°Right 35.3°Right 35.3°Right 31.6°(1)(2)(3)(4)Table (A)006363Moldingposition inFig. AMolding edge againstguide fence(1)ForoutsidecornerFor insidecornerFinished piece(2)(3)(4)Table (B)Finished piecewill be on theLeft side ofblade.Finished piecewill be on theRight side ofblade.Wall contact edge should beagainst guide fence.Wall contact edge should beagainst guide fence.Ceiling contact edge shouldbe against guide fence.006364Example:In the case of cutting 52/38° type crownmolding for position (1) in Fig. A:• Tilt and secure bevel angle setting to33.9° RIGHT.• Adjust and secure miter angle setting to31.6° RIGHT.• Lay crown molding with its broad back(hidden) surface down on the turn basewith its WALL CONTACT EDGE againstthe guide fence on the saw.• The finished piece to be used willalways be on the RIGHT side of theblade after the cut has been made.