Makita RBC411 Instruction Manual

Also see for RBC411: Instruction manual Instruction manual

Makita RBC411 Instruction Manual Manual pdf 11 page image

11– Insert the hex wrench through the hole in the gear case and rotate the receiverwasher (4) until it is locked with the hex wrench.– Loosen the nut (1) (left-hand thread) with the socket wrench and remove thenut (1), cup (2), and clamp washer (3).Mounting of cutter bladeWith the hex wrench still in place.– Mount the cutter blade onto the shaft so that the guide of the receiver washer(4) fits in the arbor hole in the cutter blade. Install the clamp washer (3), cup(2), and secure the cutter blade with the nut (1).[Tightening torque: 13 - 23 N•m]NOTE: Always wear gloves when handling the cutter blade.NOTE: The cutter blade-fastening nut (with coned disc spring) is a consumablepart.If there appears any wear or deformation on the coned disc springwasher, replace the nut.Make sure that the blade is the left way up.Mounting of cutter bladeLoosenHex WrenchTighten