Makita RBC411 Instruction Manual

Also see for RBC411: Instruction manual Instruction manual

Makita RBC411 Instruction Manual Manual pdf 9 page image

9CAUTION: Before doing any work on the brush cutter, always switch off themotor and pull the spark plug connector off the spark plug.Always wear protective gloves.CAUTION: Start the brush cutter only after having assembled it completely.– After checking the parts, fasten the drive shaft to the engine with four bolts M6x 22(1). At this time, fasten also the earth terminal (2) of the stop cord to theengine.– Place the handle with the throttle lever on the handle holder on the right side(to be held by the right hand) and the other on the left side.– Fit the handle edge to the handle holder groove, and provisionally fix theupper side (3) of the handle holder by four bolts M5 x 25 (4).– Adjust the handle to an angle easy to manipulate, and tighten the bolt (4)uniformly on the right and left sides.– Mount the waist pad (5). When the waist pad is mounted, be sure to confirmthat the wires do not move horizontally.– Avoid any tendency of the throttle wire to loop at the handle bar.The purpose of the detent lock is to prevent the engine from rotating relative tothe drive shaft while operating the starter or transporting the equipment fromplace to place. The detent should be unlocked while the unit is being used.Assembly of engine and shaftMounting of handle(4)(3)HangerDetent lock Throttle wire