UPDATE SOFTWAREUpdate current software.AIR TEMP CALIBRATIONAllows for offset of DISPLAYED AIRTEMPERATURE.LAKE TEMP CALIBRATIONAllows for offset of DISPLAYED LAKETEMPERATURE.ZERO OFFSelect if ZERO OFF gauge is installed ornot. If INSTALLED, or turned ON, then theCRUISE CONTROL MODE will be able tobe controlled only through the ZERO OFFgauge.RESTORE DEFAULTRestore back to the system factory DEFAULTSETTINGS.DIAGNOSTICView system diagnostic information concerning boatsensors and GPS signal. Follow on-screen instructionsto run DIAGNOSTIC SELF-TEST. Self-Test will takethree (3) seconds to begin.Video Screens(Optional Malibu Open Edition)In addition to the 5” gauges, controls operate through the 7” video screen rather than the LCD screen that is part of the standardpackage. Additional controls may be available through an optional 3” screen as well.ENGINE START CODEThe driver will be prompted to enter an ENGINE START CODE each timethe ignition key is cycled. The code can be CHANGED or the prompt can bedisabled, or ignition if the code prompt is disabled, the blower will turn on forfour (4) minutes in preparation of the engine starting.To CHANGE the start code, touch the CHANGE button and enter thecurrent code followed by the NEW CODE.To DISABLE the prompt, touch the DISABLE button and enter the currentcode.To RE-ENABLE the start code prompt, go into the settings menu and selectSHOW ENGINE CODE. From that menu, select the SHOW button.GAUGE VIEW AND SPEED CONTROLThe GAUGE VIEW screen provides important engine parameters and system status displayed by the speedometer, tachometer,engine temperature, oil pressure, voltage and fuel gauges. The adjustment buttons for the SPEED CONTROL cruise system are alsocontained with the GAUGE VIEW screen.Malibu Owners Manual • 2018 • Dashes and Video Screens • Page 3-18
