Chapter 1 Overview1.7 Communication to Each Output16 HORIBA1.7 Communication to Each OutputAnalog outputUse the optional exclusive cable.For connection procedure or output configuration, refer to Chapter 13 Analog Outputin page 160.Serial communication/printoutUsed for PC communication and printout.To output the data to the PC, connect the optional printer.The exclusive serial cable and the printer cable are necessary.Connection should be given with the power turned off. Connection with the power on maydamage the meter to cause a breakage.Compact flash card F-53,54,55For the detailed information on the compact flash card, refer to "11.5 Compact FlashSetting F-53, 54, 55 " p.144Ethernet output F-55To disconnect the cable, hold the connector part with a screwdriver and remove theconnector cap.Do not pull the cable forcefully.1.8 Operation of Display ValueThis meter performs measurement value operation with the digit lower than thatdisplayed in displayed values or set values, and sometimes the following situationmay occur:The inspection judgment rank may differ from the actual one when the inspectionresult is the same with that specified in the regulation.A minus indication may attach to zero in the displayed value, as -0.000.Alarm may not be triggered even when the display value should show the alarmset value.The printout data may differ in 1 digit between the display value and the printoutvalue.
