7197 Owner’s Guide CommandsMarch 2002 77Comparison ChartThe following table details the list of commands whose behavior differs from the 7193 andthe 7197 because of the physical differences of a 6 dots/mm head (7193) versus an 8dots/mm head (7197).Command Description Difference between 7193 and 7197configured in 7193 Emulation Mode.15 n Feed n Dot Rows This command will movethe paper on the receipt inn/203 inch steps instead ofn/152 inch steps.16 n Add n Extra Dot Rows The dot rows will bemeasured in n/203 inchesversus n/152 inches.1B 20 n Set Right-Side CharacterSpacingThis command sets the rightside spacing to “n”horizontal motion units. Bydefault, these units are interms of 1/203 inches versus1/152 inches.1B 24 n1 n2 Set Absolute Starting Position For graphics commands, theposition is scaled to best7193. In text mode, theequivalent character positionis calculated.1B 26 s c1 c2 n1 d1...nndn]Define User-DefinedCharacter SetSince the dots on the 7197print head are smaller, user-defined characters that wereused on the previous printerwill appear smaller on the7197 printer.1B 2A m n1 n2 d1...dn Select Bit Image Mode In 7193 Emulation Mode,graphics are scaled to bestmatch the size of the graphicin the 7193 printer.1B 33 n Set Line Spacing This command uses n interms of n/360 inches. Sincethe 7193 had a fundamentalstep of 1/152 inch and the7197 has a fundamental stepof 1/203 inch, the actual linespacing will not exactlymatch the requestedspacing.1B 4A n Print and Feed Paper (Same as above)1B 59 n1 n2 d1...dn Select Double-Density In 7193 Emulation Mode, the
