Programming Your 7890 ScannerProgramming Considerations5-4 User’s GuideTag Function IndicationDefault This tag causes the 7890 Scanner touse the program defaults. It must bethe first tag scanned after applyingpower to the scanner.Short beep - good readStatus Indicator - flash redtwiceTone - Four quick beeps fromlow to high frequencyProgrammingModeThis tag puts the 7890 Scanner in theBase Programming state. It must bethe first tag scanned after applyingpower to the scanner, or afterscanning the Default tag.Short beep - good readIn Base Programming stateLong and short beepStatus Indicator - offEnd This tag ends certain input sequences.Since the programming mode candetermine the end of most inputsequences, this tag is not used veryoften.Short beep - good readStatus Indicator - flash greenonceSave and Reset This tag causes the 7890 Scanner tosave, and start using theprogramming data. It is used in theBase Programming state.Short beep - good readStatus Indicator - flash redtwiceTone - Four quick beeps fromlow to high frequencyAbort If this tag is scanned in the BaseProgramming state, programming isterminated and no previously enteredparameters are saved.If this tag is scanned in a specificprogramming mode, all parametersentered are saved and the scannergoes to the Base Programming state.Short beep - good readStatus Indicator - flash redtwiceTone - Four quick beeps fromlow to high frequencyShort beep - good readStatus Indicator - flash greenonce
