OPTIONS INSTALLATIONTo Install Chips:Carefully read the instructions in the preparation section at thebeginning of this chapter and heed the WARNING and CAUTIONS,then proceed to add the chips as follows:1. Orient the pins correctly, make sure that pin 1 of the new chip isoriented the same as those already installed (see Figure 3-19).2. Locate the specific sockets you want to use.The chips socket locations for the MPB are shown in Figure 3-21.The memory chips on the MPB in Banks 0 and 1 may be solderedin place. You can remove the chips in Banks 2 and 3 and replacethem with higher capacity chips.If you are installing chips to an expansion board refer to thatspecific board for the correct socket locations (see Figure 3-22).Dot Note: For Pin 1 Location,4. If the pins are too wide or incorrectly angled for the socket, pressthem against a surface that is both smooth and firm. Gently rollthe chip until the pins are the correct angle.5. Gently push each chip into its correct socket. Make sure that allpins are actually in the holes.6. Set the switches on the MPB and/or expansion board as neededfor your specific installation.3-18 OWNER S MANUAL
