NEC 42 VP5 VM5 Operation Manual

Also see for PlasmaSync 42XM3: Supplementary guide Installation guide Supplementary guide Brochure Brochure

Contents

NEC 42 VP5 VM5 Operation Manual Manual pdf 6 page image

650mm (2")50mm (2") 50mm (2")WallWall50mm (2")50mm (2")You can attach your optional mounts or stand to the plasma monitor in one of the following two ways:* While it is upright. (See Drawing A)* As it is laid down with the screen face down (See Drawing B). Lay the protective sheet, which was wrapped around themonitor when it was packaged, beneath the screen surface so as not to scratch the screen face.* Do not touch or hold the screen face when carrying the unit.• This device cannot be installed on its own. Be sure to use a stand or original mounting unit. (Wallmount unit, Stand, etc.)* See the inside of the cover page.• For correct installation and mounting it is strongly recommended to use a trained, authorizeddealer.Failure to follow correct mounting procedures could result in damage to the equipment or injuryto the installer.Product warranty does not cover damage caused by improper installation.* Use only the mounting kit or stand provided by manufacturer and listed under Options.Drawing BDrawing AHow to use the safety metal fittingsand the screws for safety metalfittingsThese are fittings for fastening the unit to a wall to preventtipping due to external shock when using the stand(optional). Fasten the safety fittings to the holes in theback of the monitor using the safety fitting mount screws.Screw holeWallTable TopSafty metal fittingsScrew for Safty metalfittingsMetal chain(Not supplied)Screw or Hook etc.(Not supplied)Ventilation Requirements forenclosure mountingTo allow heat to disperse, leave space between surroundingobjects as shown on the diagram below when installing.Installation