4-50 System ConfigurationSettings on the ServerThe following describes the setting procedure.CHECK:The resolution and refresh rate of the screen that can be displayed on a remote KVM consoleare 1024x768, 75Hz and smaller respectively. If values larger than these are set, the remotescreen does not display any data. If a great value is set for the number of colors on the screenfor the server, the remote may not show colors accurately. Connecting this card to a networkwhere broadcast occurs frequently may affect remote control performance.Initial Settings on the Server1. If information specific to the server has not been written in, the following message informingyou that the server-specific information is not written is displayed while the NEC logo isdisplayed, and the startup processing of the server is paused.If this message is not displayed, the remote management function does not need to beinitialized. If it is displayed, the remote management function needs to be initialized in orderto monitor devices into details.H/W Configuration of BMC is corrupted.!! Update BMC H/W Configuration by configuration tool !!!! Refer to BMC configuration manual !!The message above may appear in a different screen during POST with the NEC logo shownand paused. In that case, press the Esc key to display the diagnosis screen to check whetheror not the above message is shown. If a different error message is shown, refer to Chapter 7“Troubleshooting.”2. How to make initial settingsEither wait for a while after the above message is shown or press the F1 key to precedePOST. Start up the “NEC EXPRESSBUILDER”DVD and select “initialize RNESteManagement Card” from the Tool menu. By doing so, information specific to each serverwill be written in.When writing the information is completed, the following message appears. Press any key toreboot the server for use.Programming complete, reboot server for normal operation.Strike a key when ready…TIPS:Running the initialize Remote Management Card resets the AC LINK setting (Server-ACLINK) of the BIOS setup to the initial value “Last State.” If you have changed the value,you will need to set it again.
