1. Installing Internal Optional DevicesExpress5800/GT110d-S User’s Guide100Chapter 2 Preparations1.13 Optical Disk DriveProcedures for replacing the standard optical disk drive with the optional internal DVD SuperMULTI drive aredescribed below.Important Do not install a drive other than those specified by NEC.1.13.1 Replacing drivesFollow the procedure below to replace your drive with the optional internal DVD SuperMULTI drive.1. Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.2. Remove the side cover and front bezel while referring to Chapter 2 (1.4 Removing the Side Cover and1.5 Removing the Front Bezel).3. While pressing the latch of the SATA cable,disconnect the SATA cable from the optical diskdrive.4. While pressing the stopper which is situated on theleft when you look at from the rear, remove theoptical disk drive from the server.5. Remove the optical disk drive from the dedicated bracket.6. Install the DVDSuperMULTI drive to the bracket for optical disk drive from which you removed theoptical disk drive in step 5.7. Install the bracket with DVDSuperMULTI drive installed to the server.8. Connect the SATA cable you disconnected in step 4 to the server.This completes the installation procedures.1.13.2 RemovalYou can remove the optical disk drive by reversing the installation procedure.
