NEC HT410 User Manual

Also see for HT410 Series: Supplementary guide Control commands Command guide Command guide Control commands

Contents

NEC HT410 User Manual Manual pdf 38 page image

E-27Optimizing an RGB Image AutomaticallyAdjusting the Image Using Auto AdjustOptimizing an RGB image automaticallyPress the AUTO ADJ. button to optimize an RGB image automatically.[Poor picture][Normal picture]Press the AUTO ADJ. button to fine-tune the computer image or to remove any vertical banding that mightappear and to reduce video noise, dot interference or cross talk (this is evident when part of your image appearsto be shimmering). This function adjusts the clock frequencies that eliminate the horizontal banding in the image.This function also adjusts the clock phase to reduce video noise, dot interference or cross talk. (This is evidentwhen part of your image appears to be shimmering.)This adjustment may be necessary when you connect your computer for the first time.NOTE:• Some signals may not be displayed correctly or take time.• The Auto Adjust function does not work for component and video signals.• If the Auto Adjust operation cannot optimize the RGB signal, try to adjust Clock and Phase manually. See page E-37.Turning Up or Down VolumeSound level from the speaker can be adjusted.increase volumedecrease volumeLAMPSTATUSPOWERON/STAND BYSELECTSOURCEAUTOADJ.POWEROFF ONS-VIDEOC-VIDEOVIDEO COMP.COMPUTERCOMPONENTAUTO ADJ.AUTORemote controlCabinet controlsLAMPSTATUSPOWERAUTOADJ.ON/STAND BYSOURCE SELECTVOLUMEMUTE FREEZE TIMERPIC-MUTE OFF TIMERHELPLIGHTKEY STONERemote controlCabinet controlsincrease volumedecrease volumeNOTE: When no menus appear, the SELECT and buttons on the projector cabinet work as a volume control.3. PROJECTING AN IMAGE (BASIC OPERATION)