NEC HT410 User Manual

Also see for HT410 Series: Supplementary guide Control commands Command guide Command guide Control commands

Contents

NEC HT410 User Manual Manual pdf 39 page image

E-28Turning off the ProjectorTo turn off the projector:First, press the ON/STAND BY button on the projector cabinet or the POWER OFF button on the remote control.The “Power Off / Are you sure?” message will appear.CONTROLS-VIDEO INRCb/PbYL/monoLAMPSTATUSPOWERAUTOADJ.ON/STAND BYSELECTSOURCEMENUONS-VIDEOC-VIDEOVIDEO COMP.COMPUTERCOMPONENTAUTOAUTO ADJ.OFF POWERRemote controlCabinet controlsPOWERSTATUSLAMPPOWERPOWERSTATUSLAMPSTATUSLAMPPower On Fan running StandbySteady green light Blinking orangelightSteady orangelightNOTE: To avoid premature lamp failure, wait at least 5 minutes before turning on or off the projector.3. PROJECTING AN IMAGE (BASIC OPERATION)Second, press the ENTER button or press the ON/STAND BY or the POWER OFF button again.The power indicator will glow orange. After the projector turns off, the cooling fans keep operating for 60 seconds(Cooling-off time).Immediately after turning on the projector and displaying an image, you cannot turn off the projector for 60seconds.Third, turn off the Main Power switch. The power indicator will go out.CAUTIONDo not unplug the power cable from the wall outlet or do not turn off the main power under any one of thefollowing circumstances. Doing so can cause damage to the projector:• While the projector is turned on.• While the cooling fans are running. (The cooling fans continue to work for 60 seconds after the projec-tor is turned off).