NEC LT150 User Manual

Also see for LT150 - MultiSync XGA DLP Projector: Technical bulletin Quick guide

Contents

NEC LT150 User Manual Manual pdf 30 page image

E–27RGBSTATUSPOWERON/STAND BYSOURCE3.OPERATIONAC INPC CARDUSBVIDEOS-VIDEORGBAUDIOPC CONTROLMENUENTERCANCELSELECTAUTOADJUSTPC CARD ACCESSSTATUSPOWERON/STAND BYSOURCE1 Connect the supplied power cable to the projector.2 Turn on and off the Projector3Connecting the Power Cable and Turn on the ProjectorPOWER ON/STAND BY buttonIndicatorTo turn on the projector:Only after you press the “POWER” button on the projectorcabinet or the remote control will the power indicator turn togreen and the projector become ready to use.NOTE: To turn the projector on by plugging in the power cable, usethe menu and enable the “Auto Start” feature. (See page E-42.)NOTE: Immediately after turning on the projector, screen flicker mayoccur. This is not a fault. Wait 3 to 5 minutes until the lamp lightingis stabilized.Power buttonTo turn off the projector:First press the “POWER” button on the projector cabinet orthe remote control for a minimum of two seconds. The powerindicator will glow orange. After the projector turns off, thecooling fans keep operating for 90 seconds.NOTE: Do not disconnect the power cable during this time. Then,unplug the power cable. The power indicator will go out.SELECTVol.Vol.POINTERPOWERHELPRD-366EPIC.MUTEMAGNIFYSOURCE AUTOADJ.MENUENTERCANCELPOWERSTATUSPOWERSTATUSON / STAND BYPOWERSTATUSPOWERSTATUSPOWERSTATUSON / STAND BYPOWERSTATUSStatus of indicator light: turn onstand byflashing 3 to 5 minutes steady lightStatus of indicator light: turn offsteady orange lightflashing green light steady green lightONcooling down stand bysteady green lightchange to flashinggreen lightsteady orange lightpress a minimum oftwo secondsSELECTVol.Vol.POINTER PIC.MUTESOURCE AUTOADJ.MENUENTERCANCELENTERAUTOADJUSTPC CARD ACCESSON/AND BYSOURCESelect the Computer or Video SourceAdjust a Projected ImagePlug the supplied power cable in the wall outlet. The projec-tor will go into its standby mode and the power indicator willglow orange.Before you turn on your projector, ensure that the computer or videosource is turned on and that your lens cap is removed.