NEC MD210C2 Installation & Maintenance Manual

Also see for MD210C2: Installation & maintenance guide

NEC MD210C2 Installation & Maintenance Manual Manual pdf 26 page image

English-24Specifications - MD211C2Monitor Specifications MD211C2 Monitor NotesLCD Module Diagonal:Viewable Image Size:Native Resolution (Pixel Count):54.0 cm/21.3 inches54.0 cm/21.3 inches1200 x 1600 (Portrait)1600 x 1200 (Landscape)Active matrix; thin fi lm transistor (TFT) liquid crystaldisplay (LCD); UA-SFT (IPS) 0.270 mm dot pitch;900 cd/m2 max luminance; 400 cd/cm2 calibratedluminance; 1400:1 contrast ratio (typical).Input SignalDisplayPort: DisplayPort Connector: Digital RGB DisplayPort Complies with Standard V1.1a,applicable to HDCPDVI: DVI-D 24pin: Digital RGB DVI, applicable to HDCPDisplay Colours 1,073,741,824 Depends on display controller used.Synchronization Range Horizontal:Vertical:31.5 kHz to 74.5 kHz, 99.4 kHz50 Hz to 85 HzAutomaticallyAutomaticallyClock Frequency 162 MHz (Max)Viewing Angle Left/Right:Up/Down:±88° (CR > 10)±88° (CR > 10)Image Formation Time 40 ms (Typ.) 20 ms (Gray to gray Typ)Resolutions Supported (Some systems maynot support all modes listed).640 x 480* 1 at 60 Hz to 85 Hz720 x 400*1 at 70 Hz to 85 Hz800 x 600*1 at 56 Hz to 85 Hz832 x 624*1 at 75 Hz1024 x 768*1 at 60 Hz to 85 Hz1152 x 864*1 at 70 Hz to 85 Hz1152 x 870*1 at 75 Hz1280 x 960*1 at 60 Hz1280 x 1024*1 at 60 Hz to 85 Hz NEC DISPLAY SOLUTIONS recommended resolution1600 x 1200 at 60 Hz........................................... for optimal display performance.1200 x 1600 at 60 Hz........................................... NEC DISPLAY SOLUTIONS recommended resolutionfor optimal display performance.Active Display Area Landscape: Horiz.:Vert.:Portrait: Horiz.:Vert.:432.0 mm/17.0 inches324.0 mm/12.8 inches324.0 mm/12.8 inches432.0 mm/17.0 inchesUSB Hub I/F:Port:Load Current:USB Specifi cation Revision 2.0Upstream 1Downstream 2Maximum 0.5A per portPower Supply AC 100-240 V ~ 50/60 HzCurrent Rating 1.1 - 0.40 A For Mexico 2.0ADimensions Landscape:Portrait:Height Adjustment:473.0 mm (W) x 393.6 - 543.6 mm (H) x 235.5 mm (D)18.6 inches (W) x 15.5 - 21.4 inches (H) x 9.3 inches (D)373.4 mm (W) x 490.6 - 593.4 mm (H) x 235.5 mm (D)14.7 inches (W) x 19.3 - 23.4 inches (H) x 9.3 inches (D)150.0 mm/5.9 inches (Landscape orientation)102.8 mm/4.0 inches (Portrait orientation)Weight 11.8 kg (26.0 lbs)/Without stand: 7.8 kg (17.2 lbs)Sensor Accuracy and RepeatabilityFront SensorAccuracy:Repeatability:Ambient SensorAccuracy:Repeatability:+/-10% (Lv>10cd/m2), +/-1cd/m2 (10cd/m2 ≧ Lv>2cd/m2), +/-0.5cd/m2 (Lv ≦ 2cd/m2)+/-2% (Standard Deviation)+/-10% (Light source: LED Lamp, Distance: 58 cm,Angle: 25 +/-5 degrees from the vertical axis of theambient sensor).+/-5% (Same as Accuracy conditions).Environmental ConsiderationsOperating Temperature:Humidity:Altitude:Atmospheric pressure:Transport/Storage Temperature:Humidity:Altitude:Atmospheric pressure:5°C to 35°C/41°F to 95°F20% to 80%-1,246 to 9,842 Feet/-380 to 3,000 m700hPa to 1060hPa-10°C to 60°C/14°F to 140°F10% to 85%-1,246 to 39,370 Feet/-380 to 12,000 m200hPa to 1060hPaAt 25 degrees, Target Brightness 400cd/m 2*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is normal andnecessary for all current fl at panel technologies when displaying non-native resolutions full screen. In fl at panel technologies, each dot on the screen is actually onepixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.NOTE: Technical specifi cations are subject to change without notice.