English-14SpecificationsMonitor Specifications MultiSync LCD1990FXp Monitor NotesLCD Module Diagonal: 48.2 cm/19.0 inches Active matrix; thin film transistor (TFT) liquidViewable Image Size: 48.2 cm/19.0 inches crystal display (LCD); 0.294 mm dot pitch;Native Resolution (Pixel Count): 1280 x 1024 250 cd/m 2 white luminence; 1500:1 contrastratio, typical.Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Digital Input: DVISync: Separate sync.TTL LevelHorizontal sync. Positive/NegativeVertical sync. Positive/NegativeComposite sync. Positive/NegativeSync on Green (Video 0.7V p-p and Sync Negative 0.3V p-p)Display Colours 16,777,216 Depends on display card used.Synchronization Range Horizontal: 31.5 kHz to 81.1 kHz AutomaticallyVertical: 56 Hz to 75 Hz AutomaticallyViewing Angle Left/Right: ±89° (CR > 10)Up/Down: ±89° (CR > 10)Image Formation Time 25 ms (Typ.)Resolutions Supported 720 x 400* 1 at 70 Hz to 75 Hz Some systems may not support all modes listed.640 x 480* 1 at 60 Hz to 75 Hz800 x 600* 1 at 56 Hz to 75 Hz832 x 624* 1 at 75 Hz1024 x 768* 1 at 60 Hz to 75 Hz NEC DISPLAY SOLUTIONS cites1152 x 870* 1 at 75 Hz recommended resolution at 60 Hz for1280 x 1024 at 60 Hz to 75 Hz.........optimal display performance.Active Landscape: Horiz.: 376 mm/14.8 inchesDisplay Area Vert.: 301 mm/11.9 inchesPortrait: Horiz.: 301 mm/11.9 inchesVert.: 376 mm/14.8 inchesPower Supply AC 100-240 V ~ 50/60 HzCurrent Rating 1.0 - 0.5 ADimensions Landscape: 392.2 mm (W) x 408.9 - 558.9 mm (H) x 247.3 mm (D)15.4 inches (W) x 16.1 - 22.0 inches (H) x 9.7 inches (D)Portrait: 326.7 mm (W) x 441.6 - 591.6 mm (H) x 247.3 mm (D)12.9 inches (W) x 17.4 - 23.3 inches (H) x 9.7 inches (D)Height Adjustment: 150 mm / 5.9 inchesWeight Net (with stand): 8.0 kg (17.6 lbs)Gross (with carton box): 10.8 kg (23.8 lbs)Environmental ConsiderationsOperating Temperature: 5°C to 35°C/41°F to 95°FHumidity: 30% to 80%Altitude: 0 to 10,000 Feet/0 to 3,048 mStorage Temperature: -10°C to 60°C/14°F to 140°FHumidity: 10% to 85%Altitude: 0 to 40,000 Feet/0 to 12,192 m*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This isnormal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot onthe screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.NOTE: Technical specifications are subject to change without notice.