NEC MultiSync LT156 User Manual

Also see for LT154 - MultiSync UXGA DLP Projector: Installation data Quick guide Quick connect guide

Contents

NEC MultiSync LT156 User Manual Manual pdf 19 page image

E – 162. INSTALLATIONThis section describes how to set up your MultiSync LT156/LT155/LT154 projector and how to connect video and audio sources.Setting up Your ProjectorYour MultiSync LT156/LT155/LT154 Projector is simple to set up and use. But before you get started, you must first:1. Determine the image size.2. Set up a screen or select a non-glossy white wall onto which you can project your image.Ensure that the power cable and any other cables connecting to video sources are disconnected before moving the projector.When moving the projector or when it is not in use, cover the lens with the lens cap.Selecting a LocationThe further your projector is from the screen or wall, the larger the image. The minimum size the image can be is approximately 25" (0.6 m)measured diagonally when the projector is roughly 3.7 feet (1.1 m) from the wall or screen. The largest the image can be is 300" (7.6 m) when theprojector is about 40.1 feet (12.2 m) from the wall or screen.Screen and Projection DistanceThe following shows the proper relative positions of the projector and screen. Refer to the table to determine the position of installation.Throw distanceScreen size (Unit: cm / inch)Screen81.3 (W) X 61.0 (H) / 32 (W) X 24 (H)61.0 (W) X 45.7 (H) / 24 (W) X 18 (H)TELE: 25"50.8 (W) X 38.1 (H) / 20 (W) X 15 (H)Lens center121.9 (W) X 91.4 (H) / 48 (W) X 36 (H)60"162.6 (W) X 121.9 (H) / 64 (W) X 48 (H)80"203.2 (W) X 152.4 (H) / 80 (W) X 60 (H)100"243.8 (W) X 182.9 (H) / 96 (W) X 72 (H)120"304.8 (W) X 228.6 (H) / 120 (W) X 90 (H)150"406.4 (W) X 304.8 (H) / 160 (W) X 120 (H)200"487.7 (W) X 365.8 (H) / 192 (W) X 144 (H)240"40"27"548.6 (W) X 411.5 (H) / 216 (W) X 162 (H)WIDE: 300"609.6 (W) X 457.2 (H) / 240 (W) X 180 (H)270"1.1/3.61.7/5.62.6/8.53.5/11.54.3/14.15.2/17.16.5/21.38.7/28.510.5/34.412.2/40.0Distance (Unit : m / feet)