NEC MultiSync LT156 User Manual

Also see for LT154 - MultiSync UXGA DLP Projector: Installation data Quick guide Quick connect guide

Contents

NEC MultiSync LT156 User Manual Manual pdf 27 page image

E – 243. OPERATIONConnecting the Power Cable and Turn on theProjectorBefore you turn on your projector, ensure that the computer or videosource is turned on and that your lens cap is removed.1. Connect the supplied power cable to the projector.MENUENTERCANCELSELECTPOWERSTATUSON/STAND BYSOURCEAUTOADJUSTPC CARDACCESSAC INC CARDUSBPC CONTROLVIDEOS-VIDEORGBAUDIOPlug the supplied power cable in the wall outlet. The projector willgo into its standby mode and the power indicator will glow orange.2. Turn on and off the ProjectorVIDEO S-VIDEO AUTO ADJ.RGB 1MENU LASERRGB 2 PJONOFFPower ON buttonMENENTERCANCELSELECTPOWERSTATUSON/STAND BYSOURCEAUTOADJUSTPC CARDACCESSPC CONTROL VIDEOS-VIDEOPower ON/STAND BY buttonIndicatorTo turn on the projector:Only after you press the “On” button on the remote control (“ON/STAND BY” button on the projector cabinet) will the power indicatorturn to green and the projector become ready to use.NOTE: To turn the projector on by plugging in the power cable, use themenu and enable the “Auto Start” feature. (See page E-38.)NOTE: Immediately after turning on the projector, screen flicker may occur.This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.To turn off the projector:First press the “off” button on the remote control (“ON/STAND BY”button on the projector cabinet) for a minimum of two seconds. Thepower indicator will glow orange. After the projector turns off, thecooling fans keep operating for one minute.NOTE: Do not disconnect the power cable during this time. Then, unplugthe power cable. The power indicator will go out.Status of indicator light: turn onPOWERSTATUSPOWERSTATUSON/STAND BYPOWERSTATUSHigh-Bright mode:stand bysteady orange lightflashing green light steady green lightflashing one minute steady lightEco mode:POWERSTATUSPOWERSTATUSPOWERSTATUS ON/STAND BYstand bysteady orange lightflashing green light(High-Bright mode)steady green light(Eco mode)flashing one minute steady lightStatus of indicator light: turn offON/STAND BYPOWERSTATUSPOWERSTATUSPOWERSTATUSONsteady green lightchange to flashinggreen lightsteady orange lightcooling down stand byPress a minimumof two seconds.