NEC MultiSync X464UN User Manual

Also see for MultiSync X464UN: User manual User manual Installation guide Installation guide User manual

Contents

NEC MultiSync X464UN User Manual Manual pdf 19 page image

English-17EnglishPicture AspectDVI, VGA, RGV/HV*4, DPORTFULL 1:1 ZOOM NORMALHDMI, Y/Pb/Pr, SCART*4, VIDEO*4, S-VIDEO*4, HDMI2*4, HDMI3*4 ,Y/Pb/Pr2* 4FULL WIDE DYNAMIC 1:1 ZOOM NORMALAspect ratioof image Unchanged view* 3 Recommended selectionfor picture aspect* 34:3NORMALDYNAMICSqueezeFULLLetterboxWIDE*3 Grey areas indicate unused portions of the screen.NORMAL: Displays the aspect ratio the same as it is sentfrom the source.FULL: Fills entire screen.WIDE: Expands a 16:9 letter box signal to fi ll entire screen.DYNAMIC: Expands a 4:3 pictures to fi ll the entire screenwith non-linearity. Some of the outside image area will be cutoff due to expansion.1:1: Displays the image in a 1 by 1 pixel format.ZOOMThe image can be expanded beyond the active display area.The image which is outside of active display area is notshown.ZOOMZOOM*4: This function depends on which option board you use.Power IndicatorMode Status Indicator LightPower ON Green*1Power OFF and Power Save “AUTOSTANDBY”Power consumption under 0.5 W*2RedPower Save “AUTO POWER SAVE”Power consumption under 2.5 WAmberPower Standby when “SCHEDULESETTINGS” enabledGreen and Amber blink alternatelyDiagnosis (Detecting failure) Red Blinking(See Troubleshooting page 47)*1 If “OFF” is selected in POWER INDICATOR (page 25), the LED will not light when theLCD monitor is in active mode.*2 Without any option, with factory settings.Initial settingsSetting LAN POWER (see page 27) and POWER SAVE(see page 26) windows appear on fi rst time the power is on.These settings are only necessary upon initial setup.However, these message window appears when the power ison after FACTORY RESET is done.When LAN POWER is set to ON and POWER SAVE is set to“DISABLE” after FACTORY RESET, then the monitor poweris off and on again, the message window will not appear.Using Power ManagementThe LCD monitor follows the VESA approved DPM DisplayPower Management function.The power management function is an energy savingfunction that automatically reduces the power consumptionof the display when the keyboard or the mouse has not beenused for a fi xed period.The power management feature on your new display hasbeen set to the “AUTO STANDBY” mode. This allows yourdisplay to enter a Power Saving Mode when no signal isapplied. This could potentially increase the life and decreasethe power consumption of the display.NOTE: Depending on the PC and display card used, thisfunction may not operate.NOTE: The monitor automatically goes into OFF at thepreset time period after signal is lost.Selecting a video source* 4To view a video source:Use the input button to set [VIDEO], [S-VIDEO].Use the COLOR SYSTEM menu to set [AUTO], [NTSC],[PAL], [SECAM], [PAL60], [4.43NTSC], according to yourvideo format.