NEC MultiSync X464UN User Manual

Also see for MultiSync X464UN: User manual User manual Installation guide Installation guide User manual

Contents

NEC MultiSync X464UN User Manual Manual pdf 31 page image

English-29English120Hz (not adjustable) -TOUCH PANEL (not adjustable) -RESET Resets the following settings within the ADVANCED OPTION menu back to factory setting:INPUT DETECT (except the priority of input signals), INPUT CHANGE (except for INPUT1 andINPUT2), TERMINAL SETTING, DEINTERLACE, COLOR SYSTEM, OVER SCAN, AUDIO inOPTION SETTING.-ADVANCED OPTION2AUTO DIMMING Adjusts the backlight of the LCD automatically depending on the amount of ambient light. -AUTO BRIGHTNESSDPORT, DVI, VGA, RGB/HV* 1 inputs onlyAdjusts the brightness level according to the input signal.NOTE: Do not select this function when ROOM LIGHT SENSING is MODE1 or MODE2.OFFROOM LIGHTSENSING* 2The backlight of the LCD screen can be set to increase or decrease depending on the amount ofambient light within the room. If the room is bright, the monitor becomes correspondingly bright. Ifthe room is dim, then the monitor will dim accordingly. The purpose of this function is to make theviewing experience more comfortable to the eye in a variety of lighting conditions.NOTE: When ROOM LIGHT SENSING is set to MODE1 or MODE2, BACKLIGHT, AUTOBRIGHTNESS and BACKLIGHT in SCREEN SAVER function are disabled.Do not cover the room light sensing sensor when you use MODE1 or MODE2.AMBIENT parameter settingROOM LIGHT SENSING in OSD, select MODE1 or MODE2 and set MAX LIMIT, IN BRIGHT andIN DARK in each mode.MAX LIMIT: This is the max level of backlight which you set.IN BRIGHT: This is the backlight level that the monitor will go up to when the ambient light level ishighest.IN DARK: This is the level of backlight that the monitor will go down to when the ambient lightlevel is low.When the ROOM LIGHT SENSING is enabled the Backlight level of the screen changesautomatically according to the lighting conditions of the room (see fi gure below).BACKLIGHT level set forthe monitor to use whenambient lighting level islow. BACKLIGHT level setfor the monitor to usewhen ambient lightinglevel is high.BACKLIGHT rangedark brightroom bright conditionScreen Backlight value by MODE2IN DARK IN BRIGHTScreen Backlight value by MODE1Factory SettingBACKLIGHT range whenset to MAX LIMIT.MAX LIMIT: BACKLIGHT level is limited to your set level.IN DARK: BACKLIGHT level set for the monitor to use when ambient lighting level is low.IN BRIGHT: BACKLIGHT level set for the monitor to use when ambient lighting level is high.OFFHUMAN SENSING* 2 HUMAN SENSING has three settings.NOTE: POWER SAVE is disabled when AUTO OFF or CUSTOM is selected in HUMANSENSING.DISABLEDISABLE No human sensing. -AUTO OFF At the preset time, when no person is detected, BACKLIGHT and VOLUME automatically gointo OFF. When a person comes near the monitor again, the monitor will automatically return tonormal mode.-CUSTOM BACKLIGHT and VOLUME automatically shift to the set value when detecting no person. Whena person comes near the monitor again, the monitor automatically return to normal mode anddisplay the input signal selected in INPUT SELECT.-INTELLI. WIRELESS DATA Select “ON” to activate INTELLIGENT WIRELESS DATA function (see page 45). A password isrequired when using the function.ONRESET Resets “ADVANCED OPTION 2” settings back to factory setting, except for INTELLI. WIRELESSDATA.-FACTORY RESET All items are returned to factory shipment state.NOTE: You can reset all items in all daisy chain displays. Please be careful to avoid resetting allitems inadvertently.-*1: This function depends on which option board you use.*2: The function is available only when connecting the optional control unit.