NEC MultiSync X464UN User Manual

Also see for MultiSync X464UN: User manual User manual Installation guide Installation guide User manual

Contents

NEC MultiSync X464UN User Manual Manual pdf 28 page image

English-26SETTING COPY In a daisy chain scenario, select the OSD menu categories that you want to copy over to theother monitor.NOTE: When you use this function, monitors should be daisy chained by LAN. This functionresets to default when power is off. This function has a limit depending on the cable you use.NOCOPY START Select “YES” and press the SET button to start copying.ALL INPUT All input terminals settings are copied when you select this item. Default is off.RESET Resets “MULTI DISPLAY” options back to factory settings except for POWER ON DELAY andVIDEO OUT SETTING.-DISPLAY PROTECTIONPOWER SAVE Sets how long the monitor waits to go into power save mode after the signal is lost.NOTE: When connecting DVI, the display card might not stop sending the digital data eventhough the image might have disappeared. If this occurs the monitor will not switch into powermanagement mode. POWER SAVE is disabled when AUTO OFF or CUSTOM is selected inHUMAN SENSING.AUTOSTANDBYAUTO POWER SAVE The monitor automatically goes into OFF at the preset time period after signal is lost.The monitor will return to normal mode when signal is restarted.-AUTO STANDBY The monitor automatically goes into OFF at the preset time period after signal is lost.Press the power button to return to normal mode.-DISABLE The monitor will not goes into OFF after signal is lost. -HEAT STATUS Displays status of the FAN, BACKLIGHT and TEMPERATURE. -FAN CONTROL Cooling fan reduces the temperature of the display to protect from overheating.If “AUTO” is selected, you can adjust the start temperature of the cooling fan and fan speed.AUTO, HIGHSCREEN SAVER Use the SCREEN SAVER function to reduce the risk of Image Persistence.GAMMA The display gamma is changed and fi xed when “ON” is selected. OFFBACKLIGHT The brightness of backlight is decreased when “ON” is selected.NOTE: Do not select this function when ROOM LIGHT SENSING is MODE1 or MODE2.OFFMOTION The screen image is slightly expanded and moves in 4 directions (UP, DOWN, RIGHT, LEFT) atuser determined intervals. You can set interval time and zooming ratio.This function is disabled when PIP, STILL, TEXT TICKER or TILE MATRIX are enabled.OFFSIDE BORDER COLOR Adjusts the color of the side borders when a 4:3 image is displayed.Press + button, the bar will become lighter.Press - button, the bar will become darker.15CHANGE PASSWORD Allows the security password to be changed.The factory preset password is 0000.-SECURITY Locks the security password.START-UP LOCK: Security password is required when the monitor power is on.CONTROL LOCK: Security password is required when the remote control button or control buttonon the monitor is pressed.BOTH LOCK: Security password is required when the monitor power is on, or the remote controlbutton or control button on the monitor is pressed.OFFRESET Resets the following settings within the DISPLAY PROTECTION menu back to factory setting:POWER SAVE, FAN CONTROL, SCREEN SAVER, SIDE BORDER COLOR.-EXTERNAL CONTROLIP ADDRESS SETTING NOTE: When changing the LAN SETTING, you need to wait several seconds until the LANSETTING is applied.IP SETTING Enabling this option automatically assigns an IP address to the monitor from your DHCP server.Disabling this option allows you to register the IP address or subnet mask number obtained fromyour network administrator.NOTE: Consult your network administrator for the IP address when “AUTO” is selected for[IP SETTING].AUTOIP ADDRESS Set your IP address of the network connected to the monitor when “MANUAL” is selected for[IP SETTING].192.168.0.10SUBNET MASK Set your subnet mask number of the network connected to the monitor when “MANUAL” isselected for [IP SETTING].255.255.255.0DEFAULT GATEWAY Set your default gateway of the network connected to the monitor when “MANUAL” is selectedfor [IP SETTING].NOTE: Set as [0.0.0.0] to delete the setting.0.0.0.0