NEC MultiSync X464UN User Manual

Also see for MultiSync X464UN: User manual User manual Installation guide Installation guide User manual

Contents

NEC MultiSync X464UN User Manual Manual pdf 33 page image

English-31EnglishREMOTE CONTROL ID FUNCTIONREMOTE CONTROL IDThe optional remote control can be used to control up to 100 individual MultiSync monitorsusing what is called the REMOTE CONTROL ID mode. The REMOTE CONTROL IDmode works in conjunction with the Monitor ID, allowing control of up to 100 individualMultiSync monitors. For example: if there are many monitors being used in the same area,a remote control in normal mode would send signals to every monitor at the same time (seeFigure 1). Using the remote in REMOTE CONTROL ID mode will only operate one specifi cmonitor within the group (see Figure 2).TO SET REMOTE CONTROL IDWhile holding down the REMOTE ID SET button on the remote control, use the KEYPAD toinput the Monitor ID (1-100) of the display to be controlled via remote. The remote can thenbe used to operate the monitor having that specifi c Monitor ID number.When 0 is selected or when the remote control is in normal mode, all monitors will beoperated.TO SET/RESET REMOTE CONTROL MODEID Mode - To enter ID Mode press the REMOTE ID SET button and hold down for2 seconds.Normal Mode - To return to Normal Mode press the REMOTE ID CLEAR button and holddown for 2 seconds.In order for this feature to work properly, the display must be assigned a Monitor ID number.The Monitor ID number can be assigned under the MULTI DISPLAY menu in the OSD(See page 24).Point the remote control towards the remote sensor of the desired monitor and press theREMOTE ID SET button. The MONITOR ID number is shown on the display when yourremote control is in ID mode.Use the remote control to operate a monitor that has a specific MONITOR ID number assigned to it.1. Set the MONITOR ID number for the display (See page 23). The MONITOR ID number can range from 1-100.This MONITOR ID number allows the remote control to operate this specifi c monitor without affecting other monitors.2. On the remote control, press and hold down the REMOTE ID SET button while using the keypad to input the REMOTE CONTROL ID number(1-100). The REMOTE ID NUMBER should match the MONITOR ID number of the display to be controlled. Choose “0” to simultaneouslycontrol all displays in range.3. Point the remote control towards the remote sensor of the desired monitor and press the REMOTE ID SET button.The MONITOR ID number is shown in red on the display.If the REMOTE CONTROLID is “0”, then all displays in range will show their respective MONITOR ID number in red.If the MONITOR ID number is shown in white on the display, the MONITOR ID number and the REMOTE CONTROL ID are not the same.NOTE: GROUP ID cannot be specifi ed via the remote control.Remote Control FunctionMonitor ID:1 Monitor ID:2 Monitor ID:3Monitor ID:1 Monitor ID:2 Monitor ID:3Remote doesnot workRemote doesnot workRemote worksRemote works Remote works Remote worksFigure 1Remote inNormal mode orthe REMOTE IDis set to 0Figure 2Remote set upto use REMOTEID:3You need an optional remote control for this function.