System Configuration 4-3Starting SETUP UtilityPowering on the server starts POST (Power On Self-Test) and displays its check results. If the NEClogo is displayed, press Esc.After a few seconds, either of the following messages appears at bottom left on the screendepending on your system configuration.Press to enter SETUPPress to enter SETUP or Press to boot from NetworkYou may see either of the following messages at bottom left on the screen when POST terminates.Press to resume, to SETUPPress F2 to start the SETUP utility and display its Main menu.If you have previously set a password with the SETUP utility, the password entry screen appears.Enter the password.Enter password:[ ]Up to three password entries will be accepted. If you fail to enter the password correctly for threeconsecutive times, the server halts. (You can no longer proceed.) Power off the server.TIPS:The server is provided with two levels of password: Supervisor and User. With the Supervisorpassword, you can view and change all system configurations. With the User password, thesystem configurations you can view or change are limited.
