NEC NC1000C Installation Manual
                                                                                                 | |
Contents
| 
41Setting Up Your Projector2-5. Mounting the Lens UnitThis device can use the following types of lens units (sold separately).MODEL Magnifying Lens memory supportNP-9LS16Z1 1.63–2.03 -NP-9LS20Z1 2.03–2.72 -NP-9LS40Z 4.07–6.34 -NP-9LS12ZM1 1.2–1.72 NP-9LS13ZM1 1.33–2.1 NP-9LS16ZM1 1.62–2.7 NP-9LS20ZM1 2.09–3.9 NP-9LS40ZM1 4.07–6.34 NOTE • The other NEC optional lenses are not available on this model.• The projector and lenses are made of precision parts. Do not subject them to shock or excessive forces.• Remove the lens unit when moving the projector. If not, the lens could be subject to shock while the projector isbeing moved, damaging the lens and the lens shift mechanism.• When mounting (removing) the lens unit, return the lens position to the center before turning off the projector power.If you do not return the lens position to the center, the lens may interfere and prevent you from removing (mounting)the front cover.• Turn off the power and wait for the cooling fan to stop and turn off the main power switch before mounting orremoving the lens.• Never touch the lens surface while the projector is operating.• Be very careful not to let dirt, grease, etc., on the lens surface and not to scratch the lens surface.• Perform these operations on a flat surface over a piece of cloth, etc., to prevent the lens from getting scratched.• When leaving the lens off the projector for long periods of time, mount the dust cap on the projector to prevent dustor dirt from getting inside.Preparation: Remove the front cover. (page 26)NOTE If you remove the front cover, the following error message is displayed on the LCD screen of the main unit operatingpanel by the tamper detection circuit.“Tamper Fail”, “Service Door Tamper”Encrypted contents cannot be displayed while an error message is being displayed. Refer to “3-2. Recovering fromTamper Errors” (page 49) for the recovery procedure.1 Remove the dust cap from the projector.2 Remove the lens cap on the back of lens.NOTE Mounting the lens with lens cap on its back to the projector can cause malfunction. |
Related manuals for NEC NC1000C
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine