34OFFVIDEOS-VIDEOVIEWERNETWORKCOMPUTERCOMPONENTONSELECTPOWERPOWERMENUE NTEREXIT31 2 Turning off the ProjectorTo turn off the projector:3. Projecting an Image (Basic Operation)1. Press the POWER (ON/STAND BY) button on the projectorcabinet or the POWER OFF button on the remote control.The [POWER OFF / ARE YOU SURE?] message will appear.2. Press the ENTER buttonAfter the projector turns off, the cooling fans keep operating fora while (Cooling-off time).The cooling fans stop operating when the projector turns offand goes into standby mode.When in standby mode, the POWER indicator will light orangeand the STATUS indicator will light green.3. After making sure that the projector is in standby mode, turnoff the Main Power switch. The power indicator will go out.About Direct power OffThe projector has a feature called “Direct Power Off”. This fea-ture allows the projector to be turned off (even when projectingan image) using a power strip equipped with a switch and abreaker.NOTE: Before using Direct Power Off, be sure to allow at least 20 min-utes immediately after turning on the projector and starting to displayan image.CAUTION• Do not unplug the power cable from the wall outlet or projec-tor when the projector is powered on. Doing so can causedamage to the AC IN connector of the projector and (or)the prong plug of the power cable. To turn off the AC powersupply when the projector is powered on, use a power stripequipped with a switch and a breaker.• Do not turn off the AC power supply within 10 seconds ofmaking adjustment or setting changes and closing the menu.Doing so can cause loss of adjustments and settings and re-turn to default.TIP: The projector can be unplugged during its cool down period after it is turned off. After Usepreparation: Make sure that the main power is turned off.1. Unplug the power cable.2. Disconnect any other cables.3. Retract adjustable tilt feet if extended.4. Cover the lens with the lens cap.OFFVIDEOS-VIDEOVIEWERNETWORKCOMPUTERCOMPONENTONSELECTPOWERPOWER31 2MENUENTEREXITUSBLAMPSTATUSPOWERON/STAND.BySOURCEAUTO.ADJUST3D.REFORMUSBLAMPSTATUSPOWERON/STAND.BySOURCEAUTO.ADJUST3D.REFORMLAMPSTATUSPOWERON/STAND BYSOURCEAUTO ADJUST3D REFORMSELECTUSBLENS SHIFTLEFTRIGHTDOWNUPWIRELESSWIRELESSLENS SHIFTLEFTRIGHTDOWNUPDownloaded From projector-manual.com NEC Manuals
