484. Convenient Features10. Press the SELECT button to highlight [OK] and press the ENTER button.The confirmation screen will be displayed.11. Press the SELECT or button to highlight [YES] and press the ENTER button.The Security Function will take effect when the projector is turned on next time.Checking If Security is enabledTurn off the projector and turn it back on to check if the Security function is enabled.1. Press the POWER (ON/STANDBY) button.the [POWer Off / are YOU sUre?] message will appear.Press the enter button or the POWer (On/standBY) or the POWer Off button again.the lamp lights off and the POWer indicator flashes orange. Please wait until the POWer indicator changesfrom flashing to steady light.2. When the POWER indicator lights steady orange, push the Main POWER switch to the off position (O).the projector will turn off.3. Push the Main POWER switch to the on position (I).the POWer indicator lights orange. the projector is in standby condition.4. Press and hold the POWER (ON/STANDBY) button for a minimum of two seconds.the projector will turn on. the [PrOJeCtOr is lOCKed! enter YOUr KeYWOrd.] message will be dis-played at the bottom of the screen.5. Press the MENU button.the Keyword entry screen will be displayed6. Press the ENTER button.the software keyboard will be displayed.7. Use the same procedures as steps 1 to 8 described in the “Assigning a Keyword for the first time” sec-tion to enter “1234”.each time one number is entered, an “” (asterisk) will appear. Keyword appears as asterisks so the real key-word is hidden.8. After entering your keyword, highlight [OK] and press the ENTER button.the software keyboard will disappear. this will allow you to operate the projector.Downloaded From projector-manual.com NEC Manuals
