6. Maintenance105o Replacing Consumable PartsDuring the course of normal usage, consumable parts become worn out resulting in reducedperformance. The following guides detail how to replace the various consumable parts withinthe projector quickly and safely.Before replacing any of the parts, please take note of the following:• Ensure that the projector is turned off and disconnected from the power supply.• Ensure that the projector is in a clean, stable position before replacing parts.• Allow at least one hour after shutdown for the projector to cool before attempting toreplace any consumable parts.• Do not interchange Lamp 1 and Lamp 2 after the projector has been used once.Doing so will not allow the projector to display the correct lamp usage hours.• A minimum space is required for replacement. See pages 27 and 106 for more de-tails.Replacing the FiltersWhen the lamps are replaced, the filters should also be replaced, not cleaned.Refer to the following guide to replace the filters.CAUTION:Do not drop the projector on your hand or fingers while lifting the projector toreplace the filters. Doing so could injure your hand or fingers.Note:The filters on the side and the rear are located on the bottom.1. Gently slide the filtercovers in the directionshown.2. Lift the foam from allthree filters in thedirection shown. Removecompletely from the filtercover and discard.Downloaded From projector-manual.com NEC Manuals
