27USBLAMPSTATUSSOURCEAUTO ADJUST3D REFORMSELECT12Adjusting the Tilt Foot1. Lift the front edge of the projector.CAUTION:Do not try to touch the ventilation outlet during Tilt Foot adjustmentas it can become heated while the projector is turned on and duringits cool down period after it is turned off.2. Push up the Adjustable Tilt Foot Lever on the front of the projectorto extend the adjustable tilt feet (maximum height).3. Lower the front of the projector to the desired height.4. Release the Adjustable Tilt Foot lever to lock the Adjustable tilt foot.there is approximately 10 degrees (up) of adjustment for the front ofthe projector.adjustable tiltfoot leverNOTE: Your “Keystone” correction data can be reset by pressing and holdingthe 3D REFORM button for a minimum of 2 seconds.CAUTION:Do not use the tilt-foot for purposes other than originally intended.Misuses such as using the tilt foot to carry or hang (from the wall orceiling) the projector can cause damage to the projector.The rear foot height can be adjusted up to 0.5 inch/13 mm.Rotate the rear foot to the desired height in order to square the imageon the projection surface, but the vertical distance from the bottom to thedesk or floor should be 0.5 inch /13mm to make the projector horizontalon the flat surface.TIP: For operating the [KEYSTONE] screen, see “ Correcting Keystone Dis-tortion” on page 28.3. Projecting an Image (Basic Operation)USBLAMPSTATUSSOURCEAUTO ADJUST3D REFORMSELECT43adjustable tilt foot
