NEC NP901W User Manual

Also see for NP901W: Control commands Specifications Quick setup guide Installation guide Network Setup

Contents

NEC NP901W User Manual Manual pdf 5 page image

iiiImportant InformationRF Interference (for USA only)WARNINGThe Federal Communications Commission does not allow any modifications or changes to the unit EXCEPTthose specified by NEC Display Solutions of America, Inc. in this manual. Failure to comply with this governmentregulation could void your right to operate this equipment. This equipment has been tested and found to complywith the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference in a residential installation. This equipment generates,uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is no guarantee that interference willnot occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio / TV technician for help.For UK only: In UK, a BS approved power cable with moulded plug has a Black (five Amps) fuse installed for usewith this equipment. If a power cable is not supplied with this equipment please contact your supplier.Important SafeguardsThese safety instructions are to ensure the long life of your projector and to prevent fire and shock. Please readthem carefully and heed all warnings.Installation• Do not place the projector in the following conditions:- on an unstable cart, stand, or table.- near water, baths or damp rooms.- in direct sunlight, near heaters or heat radiating appliances.- in a dusty, smoky or steamy environment.- on a sheet of paper or cloth, rugs or carpets.• If you wish to have the projector installed on the ceiling:- Do not attempt to install the projector yourself.- The projector must be installed by qualified technicians in order to ensure proper operation and reduce therisk of bodily injury.- In addition, the ceiling must be strong enough to support the projector and the installation must be in accor-dance with any local building codes.- Please consult your dealer for more information.10˚Place the projector in a horizontal positionThe tilt angle of the projector should not exceed 10 degrees, nor should the projector be installed in any way otherthan the desktop and ceiling mount, otherwise lamp life could decrease dramatically.