NEC PlasmaSync 42VP4 User Manual

Also see for 42VP4A: Model information

Contents

NEC PlasmaSync 42VP4 User Manual Manual pdf 3 page image

PrecautionsPlease read this manual carefully before using your plasmamonitor and keep the manual handy for future reference.CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPENCAUTION: TO REDUCE THE RISK OF ELECTRICSHOCK, DO NOT REMOVE COVER. NOUSER-SERVICEABLE PARTS INSIDE.REFER SERVICING TO QUALIFIEDSERVICE PERSONNEL.This symbol warns the user that uninsulatedvoltage within the unit may have sufficientmagnitude to cause electric shock.Therefore, it is dangerous to make any kindof contact with any part inside of this unit.This symbol alerts the user that importantliterature concerning the operation andmaintenance of this unit has been included.Therefore, it should be read carefully inorder to avoid any problems.WARNINGTO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSETHIS UNIT TO RAIN OR MOISTURE. ALSO DO NOT USETHIS UNIT’S POLARIZED PLUG WITH AN EXTENSION CORDRECEPTACLE OR OTHER OUTLETS, UNLESS THEPRONGS CAN BE FULLY INSERTED. REFRAIN FROMOPENING THE CABINET AS THERE ARE HIGH-VOLTAGECOMPONENTS INSIDE. REFER SERVICING TO QUALIFIEDSERVICE PERSONNEL.WarningThis equipment has been tested and found to comply withthe limits for a Class A digital device, pursuant to Part 15 ofthe FCC Rules. These limits are designed to providereasonable protection against harmful interference whenthe equipment is operated in a commercial environment.This equipment generates, uses, and can radiate radiofrequency energy and, if not installed and used inaccordance with the instruction manual, may cause harmfulinterference to radio communications. Operation of thisequipment in a residential area is likely to cause harmfulinterference in which case the user will be required to correctthe interference at his own expense.Important InformationWarnings and Safety PrecautionThis plasma monitor is designed andmanufactured to provide long, trouble-free service.No maintenance other than cleaning is required.Please see the section “Plasma monitor cleaningprocedure” on the next page.The plasma display panel consists of fine pictureelements (cells) with more than 99.99 percent activecells. There may be some cells that do not producelight or remain lit.For operating safety and to avoid damage to the unit,read carefully and observe the following instructions.To avoid shock and fire hazards:1. Provide adequate space for ventilation to avoid internalheat build-up. Do not cover rear vents or install the unitin a closed cabinet or shelves.If you install the unit in an enclosure, make sure thereis adequate space at the top of the unit to allow hot airto rise and escape. If the monitor becomes too hot, theoverheat protector will be activated and the monitor willbe turned off. If this happens, turn off the power to themonitor and unplug the power cord. If the room wherethe monitor is installed is particularly hot, move themonitor to a cooler location, and wait for 60 minutes tocool the monitor. If the problem persists, contact yourdealer for service.2. Do not use this unit’s polarized plug with extension cordsor outlets unless the prongs can be completely inserted.3. Do not expose the unit to water or moisture.4. Avoid damage to the power cord, and do not attempt tomodify the power cord.5. Unplug the power cord during electrical storms or ifthe unit will not be used over a long period.6. Do not open the cabinet which has potentially dangeroushigh voltage components inside. If the unit is damaged inthis way the warranty will be void. Moreover, there is aserious risk of electric shock.7. Do not attempt to service or repair the unit. Themanufacturer is not liable for any bodily harm or damagecaused if unqualified persons attempt service or openthe back cover. Refer all service to authorized ServiceCenters.