PowerMate 2000 Series Release Notes A-3Do not install both the NEC SNMP Agent and LANDeskClient Manager on the same computer.See “NEC Application and Driver CD” in Chapter 3 of the PowerMate 2000Series User’s Guide for detailed information about installing applications fromthe NEC Application and Driver CD.Installing NEC SNMP AgentSee the previous section “Installing Applications in the Correct Order” and see“NEC SNMP Agent” in Chapter 4 of the PowerMate 2000 Series User’s Guidefor detailed installation information.Do not install both the NEC SNMP Agent and LANDeskClient Manager on the same computer.Uninstalling the NEC SNMP Agent or LANDesk Client ManagerLANDesk Client Manager and the NEC SNMP Agent are not fully compatiblewhen both are installed on the same computer. See the following sections forinformation about uninstalling these applications.When Both NEC SNMP Agent and LANDesk Client Manager Are InstalledIf both applications have been installed, LANDesk Client Manager does notfunction correctly, and cannot display ASIC-related tabs for temperature, fan,voltage, and chassis intrusion status.In addition, each time the computer is restarted, a Service Control Managerwindow displays an error message and prompts the user to press Enter.If LANDesk Client Manager and the NEC SNMP Agent have both beeninstalled, it is not possible to remove either application using the uninstallutility. If you attempt to remove one of the applications, you must perform a fulloperating system restore using the NEC OS Restore CD.After the full restore, reinstall all appropriate applications from the NECApplication and Driver CD. Do not reinstall both LANDesk Client Manager andthe NEC SNMP Agent.