3-2 Disassembly and ReassemblyThis section contains step-by-step disassembly procedures for the PowerMate2000 series system. A disassembly figure is provided with most procedures.Section 5 includes a field-level parts list and an illustrated parts breakdownshowing an exploded view of the system.A small flat head screwdriver and a small Phillips-head screwdriver are the onlyrequired tools. For complete disassembly of the system unit, follow thedisassembly order listed in the following table. To reassemble, follow the tableand procedures in reverse order. Where reassembly is not readily apparent,reassembly procedures are provided.PowerMate 2000 Series Disassembly SequenceSequence Part Name See Page1 Hard Drive 3-32 SO-DIMM Memory Module(s) 3-53 Bottom Cover 3-74 CD-ROM Drive 3-85 Diskette Drive 3-96 System Board and Support Plate Assembly 3-107 Support Plate 3-128 Network Board Assembly 3-139 LAN Connector Board 3-1410 PC Card Bay 3-1411 CMOS Battery 3-1512 CPU Fan 3-1613 Processor and Heat Sink 3-1714 Hard Drive Bay and Drive 3-2012 LCD Panel 3-20When disassembling the system, follow these general rules.! Turn off the system and disconnect the AC power adapter and power cordfrom the power source and system unit.! Disconnect all peripherals before disassembling the system.! Before opening the system unit or handling boards or chips, touch themetal bottom cover on the system unit to discharge static.! Do not disassemble parts other than those specified in the procedure.! All screws are Phillips-head, unless otherwise specified.! Observe each cable connector before attempting to disconnect. Someconnectors have a retainer holding them in place.
