PowerMate 2000 Series Release Notes A-5Installing PartitionMagicInstall PartitionMagic™ files from the NEC Application and Driver CD. Selectthe PartitionMagic software from the Applications tab in the Installation utilitymenu. The utility loads files from the NEC Application and Driver CD toC:\Program Files\PowerQuest\PartitionMagic4. You can find setup anddocumentation files in the following folders:! Btmagic! Diskette! Setup! Userinfo.If the PartitionMagic setup program asks you for a serial number, enter thefollowing number:PM400ENOEMCD-673785See the documentation in the Userinfo folder for information about usingPartitionMagic, BootMagic™, and the recovery diskette program. Reading theUserinfo files requires Adobe® Acrobat ® Reader. Adobe Acrobat Reader comeson the NEC Application and Driver CD.Note: If you are installing BootMagic in a system withthe Windows NT operating system, see the next section,“Installing BootMagic in a System with Windows NT.”Installing BootMagic in a System with Windows NTBootMagic™ is a utility included in the PowerQuest PartitionMagic™ software.See the previous section, “Installing PartitionMagic,” for general installationinformation.If you have a Windows NT operating system, use the information in thefollowing section to correctly configure BootMagic.If you already installed BootMagic and the configuration resulted in an errormessage, see “Correcting the BootMagic Configuration.”Configuring BootMagicIf you have a system with the Windows NT operating system, use the followingprocedure to correctly configure BootMagic.1. Follow the instructions in the PartitionMagic Userinfo folder to installBootMagic. When the “BootMagic Configuration” box appears at the end ofthe installation, continue to the next step.